Abstract:Due to its ideal optical and electrical properties for upcoming electronic devices, Cu2O is commonly regarded as one of the most promising p-type oxides. Copper (Cu) rapidly deposits mixed phases of its oxides. This article describes the spray deposition method for developing copper oxide thin films at temperatures between 200 and 400 °C on glass substrates coated with ITO. Through optimization of the deposition temperature, Cu2O-rich phases were attained in the copper oxide films, typically around 300 °C. A Cu-rich phase was seen at 200 °C deposition temperature, and this phase progressively diminished at higher temperatures. At 400 °C, the CuO phase began to enrich the films in the meantime. Analysis using an X-ray diffraction (XRD) verified the existence of Cu2O phases (111), (200), and (220). The crystallites were discovered to be between 17.49 and 20.32 nm in size for the films deposited between 300 and 400 °C. The X-ray Photoelectron Spectroscopy (XPS) identifies Cu and oxygen as the main components. Furthermore, it is demonstrated that the deposition temperature significantly affects the copper's oxidation state. The Atomic Force Microscopy (AFM) investigation showed that as the temperature increased, surface roughness decreased. As the deposition temperature enhanced, the energy band gap of the deposited films widened from 1.67 to 2.85 eV, as observed by the UV-VIS-NIR spectrophotometer. Moreover, the fabrication of Schottky diodes with Cu metal contacts is also reported. These fabricated diodes showed a proportionate rise in barrier height with increasing deposition temperatures.

Photo-sensing characteristics of CuO thin films synthesized by thermal oxidation of Cu metal films

Microstructure, Morphology and Sunlight Response of Cuprous Oxide Thin Films

Effect of solution concentration on surface morphology, chemical composition and photoresponse of CuO/Cu 2 O composite thin films grown by hydrothermal synthesis

Effect of Annealing Temperature and CuO on Microstructure and Optical Band Gap of CuxZn1−xO Thin Films

Electrical and optical properties of copper oxide thin films prepared by DC magnetron sputtering

Properties of Spray Pyrolysied Copper Oxide Thin Films

Tuning Band Gaps and Photoelectrochemical Properties of Electrodeposited CuO Films by Annealing in Different Atmospheres

Optical and Electrical Properties of Copper Oxide Thin Films Synthesized by Spray Pyrolysis Technique

Study of the structural, optical, electrical and electrochemical properties of copper oxide thin films synthesized by spray pyrolysis

Study on the electronic and structural properties of oxidized copper films

Effect of CuI Layer on Photoelectrochemistry of Cu2O Films

Preparation and Characterization of Copper Oxide Thin Films Deposited by Filtered Cathodic Vacuum Arc

Study of Deposition Temperature Effect on Spray-Deposited Copper Oxide Thin Films and Its Schottky Diodes

The Optical and Electrical Performance of CuO Synthesized by Anodic Oxidation Based on Copper Foam

Optical Properties of CuCdS Thin Film Prepared by Vacuum Thermal Evaporation Technique

Standardizing the optimal photo-diode performance of CuO nanostructures through various morphological patterns

Oxide phase and conductivity-type of copper oxide thin films deposited by direct current magnetron sputtering

Investigation of the Optical and Dielectric Behaviour of SnO2-CuO Mixed Oxides Thin Films

Fabrication and Characterization of SnO-Cu₂O Mixed Metal Oxide Thin Films for Photoelectrochemical Applications

Influence of Deposition Temperature on Growth Process and Opto-electronic Performance of Cu2O Thin Films

Effects of oxidation on the localized surface plasmon resonance of Cu nanoparticles fabricated via vacuum coating