Abstract:Cu2O/CuO bilayers were fabricated by electrodeposition of the CuO layer in a copper(II)-ammonia complex aqueous solution, followed by photoelectrochemical deposition of the Cu2O layer at potentials ranging from -0.3 to -1.0 V referenced to a Ag/AgCl electrode in a copper(II)-lactate complex aqueous solution under light irradiation, and the effects of varied potentials of the photoelectrochemical Cu2O depositions and post-heating conditions on their structural, optical, and photovoltaic characteristics were investigated with X-ray diffraction, field emission-scanning electron microscopy, optical absorption measurements, and external quantum efficiency (EQE) measurements with and without applied bias voltage. The Cu2O layers with a characteristic 2.1 eV band gap energy were adhesively stacked on the thorn-like grains of the CuO layers possessing a characteristic 1.5 eV band gap energy, and dense and defect-free Cu2O/CuO bilayers could be fabricated at the potentials of -0.4 and -0.5 V, but the grain size of Cu2O decreased at -0.5 V. In addition, the metallic Cu was deposited simultaneously at potentials less than -0.7 V. The Cu2O/CuO bilayer fabricated at -0.4 V revealed photovoltaic features at wavelengths ranging from 350 nm to approximately 900 nm, and a maximum EQE value of 56.8% was achieved at 510 nm in wavelength with a bias voltage of -0.1 V. The maximum EQE value, however, decreased to 1.2% accompanied with the peak wavelength shift to 580 nm, and no photovoltaic feature was observed at potentials of -0.3, -0.7, and -1.0 V. The photovoltaic performance for the Cu2O/CuO bilayer fabricated at -0.4 V was ameliorated by heating at 423 K, and the maximum EQE values were enhanced to 87.7% at 550 nm and 89.8% at 530 nm in an ambient atmosphere and vacuum. Both the Cu2O and CuO layers acted as photovoltaic layers in the Cu2O/CuO bilayer fabricated at -0.4 V and heated at 423 K, and the electrical characteristic including the carrier mobility affected the photovoltaic performance. The photovoltaic feature, however, disappeared by heating above 523 K due to the formation of nanopores inside the CuO layer and near the CuO heterointerface to the Cu2O and fluorine-doped tin oxide substrate.

Effect of CuI Layer on Photoelectrochemistry of Cu2O Films

Reaction-induced Iodine Adsorption on Cu Surfaces Facilitates Electrocatalytic CO2 Reduction.

Effect of solution concentration on surface morphology, chemical composition and photoresponse of CuO/Cu 2 O composite thin films grown by hydrothermal synthesis

Electrodeposited Cu2O on the {101} Facets of TiO2 Nanosheet Arrays and Their Enhanced Photoelectrochemical Performance

Electrodeposition and Optical Properties of Highly Oriented Γ-Cui Thin Films

Effect of seed layer on optical properties and visible photoresponse of ZnO/Cu 2 O composite thin films

EPIR Effect of Cu2O Films by Electrochemical Deposition

Effects and Mechanism of ITO and ZnO Substrate on Surface Morgraphology and Structural of Electrodeposited Cu2O Thin Films

Epitaxial Electrodeposition of Cu2o Films Onto Inp(001)

Tuning Band Gaps and Photoelectrochemical Properties of Electrodeposited CuO Films by Annealing in Different Atmospheres

Effect of pH on the electrodeposition nucleation and growth mechanism of cuprous oxide

Electrodeposition of AgCuO2 Nanoplates

Effect of Conductive Substrate (working Electrode) on the Morphology of Electrodeposited Cu2O

Photoelctrochemically Fabricated and Heated Cu2O/CuO Bilayers with Enhanced Photovoltaic Characteristics

In-Depth Study of Chemically Electrodeposited Cuprous Oxide (Cu2O) thin Films on ITO Glass

Role of TiO 2 coating layer on the performance of Cu 2 O photocathode in photoelectrochemical CO 2 reduction

Research on CuInS2 Thin Films Prepared by One-step Electrodeposition

Study on photoelectrochemical CO2 reduction over Cu2O

Study on nanoporous CuBi2O4 photocathode coated with TiO2 overlayer for photoelectrochemical CO2 reduction

Effects of Cu2O thickness on the photoelectrochemical properties of Cu2O/WO3 heterostructure

Influence of CO Adsorption on the Structure of Electric Double Layer on Cu Surface