Abstract:It is demonstrated that cuprous oxide (Cu2O) can be electrodeposited epitaxially onto silicon (Si) and indium phosphide (InP) (001) single‐crystalline substrates from aqueous solution. Epitaxial electrodeposition under these conditions is remarkable considering the strong driving force for the formation of amorphous native oxide layers on Si and InP substrates. To elucidate the growth mechanisms, the microstructure of the interfaces between the Cu2O layer and the two different substrates was investigated by TEM (transmission electron microscopy) in conjunction with XEDS (X‐ray energy‐dispersive spectroscopy) and EELS (electron energy‐loss spectroscopy). In both heteroepitaxial systems, the Cu2O layers have a unique but non‐trivial crystallographic orientation relationship (OR) with the substrate, which can be described as a 45° rotation around the common [001] axis representing the substrate normal. We show that this relationship minimizes the overall misfit between corresponding interatomic spacings of the two adjacent crystals. In apparent contradiction to the unique OR, TEM revealed that in both hetero‐systems the Cu2O layer is separated from the substrate by an amorphous interlayer. The thickness of the interlayer typically is a few nanometers. The presence of an amorphous interlayer contrasts with our experimental results on electrodeposited Cu2O on Au (001) single‐crystal substrates, also included in this article, where TEM shows the Cu2O epilayer in direct contact with the substrate. XEDS and EELS analysis of the chemical composition and bonding at Cu2O/Si and Cu2O/InP interfaces in the as‐grown state as well as after tempering revealed that the interlayer is mainly composed of SiO2 and InPO4, respectively. Most likely, the observed epitaxial layers on top of an amorphous interlayer evolve by nucleation of epitaxial Cu2O directly on the substrate. While simultaneous oxidation of the substrate leads to the formation of an amorphous layer, the epitaxial nuclei can laterally overgrow the oxide. Consequently, the local composition of the amorphous layer varies with the nature of the substrate.

Electrodeposition and Optical Properties of Highly Oriented Γ-Cui Thin Films

Growth and Characterization of Highly Oriented CuBr Thin Films Through Room Temperature Electrochemical Route

Room Temperature Electrodeposition of Oriented Agi Crystals

Epitaxial Electrodeposition of Cu2o Films Onto Inp(001)

Effect of CuI Layer on Photoelectrochemistry of Cu2O Films

Research on CuInS2 Thin Films Prepared by One-step Electrodeposition

Growth of Cubic MgxZn1-xO Films and Characterization

(211)-Orientation preference of transparent conducting In2O3:Sn films and its formation mechanism

Fabrication and characterization of CuInS 2 films by chemical bath deposition in acid conditions

Structure and Dielectric Properties of Highly (100)-Oriented PST Thin Films Deposited on MgO Substrates

EPITAXIAL GROWTH OF CUPROUS OXIDE ELECTRODEPOSITED ONTO SEMICONDUCTOR AND METAL SUBSTRATES

Oriented Hexagonal Phase NaGdF<sub>4</sub>:Eu<SUP>3+</SUP> Films Made through Electrodeposition

In-Depth Study of Chemically Electrodeposited Cuprous Oxide (Cu2O) thin Films on ITO Glass

Surface-enhanced p-type transparent conducting CuI−Ga2O3 films with high hole transport performance and stability

Highly transparent and conductive p-type CuI films by optimized solid-iodination at room temperature

High-Performance p-Type Transparent Conducting CuI−Cu2O Thin Films with Enhanced Hole Mobility, Surface, and Stability

Efficient field emission from well-oriented Cu2O film

Hybrid Influences of Defect Dipole and Intrinsic Inducing Field on Orientation of PbTiO3 Thin Film Deposited on Indium Tin Oxide/glass Substrate

Influence of Deposition Temperature on Growth Process and Opto-electronic Performance of Cu2O Thin Films

Electrochemical Synthesis and Optical Properties of ZnO Thin Film on In2O3:Sn (Ito)-Coated Glass

Alignment controllable synthesis of MOF films: From Cu(OH)2 nanowire array to highly oriented Cu-MOF film