Abstract:p-Type hydrogenated silicon carbide (p-SiC:H) films were prepared using plasma-enhanced chemical vapor deposition by systematically incorporating carbon into nanocrystalline silicon networks. The carbon content of the films was varied by adjusting the methane/silane (CH4/SiH4; R-c) ratio. The chemical bonding, micro structural, and electro-optical properties of the films were investigated in detail. With increasing R-c,R-, the silicon carbon bond density in the films increased gradually and the overall microstructure became amorphous. Through sophisticated control of the carbon content of the films during high hydrogen dilution deposition, p-type hydrogenated nanocrystalline SiC:H (p-nc-SiC:H) films with nanometer-scale Si crystallites embedded in an amorphous SiC:H matrix were obtained. The p-nc-SiC:H films had wide bandgaps larger than 2 eV and reduced parasitic light absorption at wavelengths below 550 nm. When using wide-bandgap p-nc-SiC:H films with superior electro-optical properties as window layers in n-i-p flexible and p-i-n semi-transparent nc-Si:H solar cells, in place of conventional p-nc-Si:H layers with narrow bandgaps, enhanced cell performance was achieved because of both high open circuit voltage (V-oc) and high quantum efficiency values at short wavelengths of 350-550 nm. The conversion efficiencies of the flexible nc-Si:H solar cells increased from 6.37% (V-oc = 0.41 V, J(sc) = 22.81 mA/cm(2), and FF = 68.10%, where Jsc is the short-circuit current density and FF is the fill factor, respectively) to 7.89% (Voc = 0.51 V, J(sc) = 24.04 mA/cm(2), and FF = 64.37%). A further increase in the conversion efficiency to 9.18% was obtained by inserting a very thin, highly-doped p-nc-SiC:H buffer layer between a low-doped p-nc-SiC:H window layer and an indium tin oxide front contact. A significant increase in the conversion efficiency from 3.66% (V-oc = 0.42 V, J(sc) = 14.83 mA/cm(2), and FF = 58.69%) to 4.33% (V-oc = 0.45 V, J(sc) = 17.74 mA/cm(2), and FF = 54.18%) was achieved with the semi-transparent nc-Si:H solar cell, with an average optical transmittance of 17.29% in the visible wavelength region of 500-800 nm.

Polarizable High‐Index Nanoparticles Used for Light‐Induced Crystal‐Silicon Passivation and Dielectric Antenna for High‐Efficiency Solar Cell

Silicon Nanocrystal Conjugated Polymer Hybrid Solar Cells with Improved Performance

Controllable Nanoscale Inverted Pyramids for Highly Efficient Quasi-Omnidirectional Crystalline Silicon Solar Cells.

Quasi‐Omnidirectional Ultrathin Silicon Solar Cells Realized by Industrially Compatible Processes

Surface plasmon resonance enhanced highly efficient planar silicon solar cell

Enhanced Device Performance of Si Nanowires/si Nanocrystals Heterojunction Solar Cells with Ultrathin Al2O3 Passivation

Antireflection Properties and Solar Cell Application of Silicon Nanostructures

An effective way to simultaneous realization of excellent optical and electrical performance in large‐scale Si nano/microstructures

Nanocrystalline‐silicon hole contact layers enabling efficiency improvement of silicon heterojunction solar cells: Impact of nanostructure evolution on solar cell performance

Ultra-Broadband Directional Scattering by Colloidally Lithographed High-Index Mie Resonant Oligomers and Their Energy-Harvesting Applications

Designing High-Efficiency Thin Silicon Solar Cells Using Parabolic-Pore Photonic Crystals

Interface Engineering For Both Cathode And Anode Enables Low-Cost Highly Efficient Solution-Processed Cdte Nanocrystal Solar Cells

Interfacial Engineering of Cu 2 O Passivating Contact for Efficient Crystalline Silicon Solar Cells with an Al 2 O 3 Passivation Layer

Improved Surface Passivation by Wet Texturing, Ozone‐Based Cleaning, and Plasma‐Enhanced Chemical Vapor Deposition Processes for High‐Efficiency Silicon Heterojunction Solar Cells

Micro- and nano-scale optical focusing for carrier management in silicon solar cell

Efficiency Enhancement of c-Si/TiO$_2$ Heterojunction Thin Film Solar Cell Using Hybrid Metal-Dielectric Nanostructures

Optical absorption enhancement in amorphous silicon nanowire and nanocone arrays.

Efficient carrier transport via dual-function interfacial engineering using cesium iodide for high-performance perovskite solar cells based on NiOx hole transporting materials

Wide-bandgap Nanocrystalline Silicon-Carbon Alloys for Photovoltaic Applications

Conductive Hole-Selective Passivating Contacts for Crystalline Silicon Solar Cells

Optimal Design of Ultra‐broadband, Omnidirectional, and Polarization‐insensitive Amorphous Silicon Solar Cells with a Core‐shell Nanograting Structure