Abstract:One of the main problems of the modern world is the search for economy of energy resources that could compete with natural gas. High-temperature furnaces are one of the biggest consumers of fuel. The heat-technology installation (furnace unit) is a set of working space within which a high-temperature process is carried out, and the equipment that ensures its implementation. The upper part of the reactor enclosure (working space) is called the vault. The vault is an element that determines the stability of the unit in general and affects the technical and economic indicators of production. On furnaces with intensive blowing of the bath with oxygen, the stability of the vault is about 300 melts. In the course of the technological process, the furnace vault is affected by the following factors: uneven heating of the inner surface of the vault along the length and width due to the uneven temperature field of the torch when heating the unit; temperature fluctuations depending on technological periods; a change in the chemical and phase composition of the refractory vault material as a result of the influence of slag and metal splashes, smelting dust and the gas atmosphere of the working space of the furnace. The intensification of thermal and technological regimes contributes to strengthening and accelerating the action of the above-mentioned processes. Therefore, special attention should be paid to the issue of high-quality heating of the vault of the unit. The article presents the results of studies of factors affecting the stability of the vault of high-temperature aggregates. On the basis of calculations based on the heat balance equations of the high-temperature unit, as well as recommendations for heating refractory products. In this article has been developed a new rational heating mode. The new thermal mode of heating the vault of the furnace will ensure a uniform temperature gradient over the entire surface of the vault, as well as the space of the furnace: with exposure to 300°С and 800°С in the zones of increased linear expansion of directly bonded high-temperature products. And also increase the productivity of the unit due to faster entry into the working mode. The fuel reduction for the heating process is estimated about 10.7%.

Improvement of the gas-dynamic and thermal modes of external heating of a sintering mixture layer

Simulation of temperature field of sintering ignition furnace

Study on Influence of Air Distribution in Sintering Process on Sinter Quality

Sintering process with gaseous fuel injection into the sintered layer

Affection of heat preservation system on surface layer sinter quality

IMPROVEMENT OF THERMAL MODES OF WARMING UP HIGH-TEMPERATURE UNITS

Furnace devices aerodynamics optimization for fuel combustion efficiency improvement and nitrogen oxide emission reduction

Simulation of heat-transfer conditions and development of a method for heating a sinter charge with water preheated using the heat of exhaust gases

Optimization of cemented carbide sinter-HIP furnace

A new approach of preheating and powder sintering in electron beam powder bed fusion

Promotion of the Mixing Performance of Heated Gas and Low-Temperature Sintering Gas in Selective Catalytic Reaction Facilities

Effect of furnace atmosphere on sintering process of chromium-containing steel via powder metallurgy

Experimental Investigation on the Mixing Performance of Heating Gas into the Low Temperature Sintering Flue Gas Selective Catalyst Reaction Facilities

INCREASING THE EFFICIENCY OF FUEL COMBUSTION IN AIR HEATERS OF BLAST FURNACES

Numerical simulation of gas-solid heat transfer and moisture evaporation process in preheating shaft kiln for ferromagnesium pellets

Improvement of Heat Pattern and Sinter Strength at High Charcoal Proportion by Applying Ultra-Lean Gaseous Fuel Injection in Iron Ore Sintering Process

CFD Prediction of Heat/mass Transfer in Multi-Layer Sintering Process Assisted with Gaseous Fuel Injection

Numerical Investigation of Gas-Solid Heat Transfer Process and Parameter Optimization in Shaft Kiln for High-Purity Magnesia

Optimization of Gaseous Fuel Injection for Saving Energy Consumption and Improving Imbalance of Heat Distribution in Iron Ore Sintering

Numerical modeling and parameter optimization of the combustion chamber in a tower-type zinc refining furnace

Change of the Mineral Wool Cupola Operating Conditions During the Transition from the Open Gas Flow Mechanism to the Closed One