Microstructure and Mechanical Properties of a Two‐Phase Mg–Li Alloy Processed By Constrained Groove Pressing

Zongshen Wang,Bin Zhang,Wei Zhou,Lihua Zhu,Hongyu Zheng,Yanjin Guan,Wengang Zhai

DOI: https://doi.org/10.1002/adem.202000614

IF: 3.6

2020-09-02

Advanced Engineering Materials

Abstract:<p>Constrained groove pressing (CGP), as a novel severe plastic deformation method, is applied to a two‐phase Mg‐Li alloy at room temperature, 373 K, 423 K and 473 K. The microstructural evolution and mechanical properties of Mg‐Li alloy sheets during CGP are investigated. The optimum mechanical properties are achieved at 373 K after two passes. The tensile strength and yield strength are 157 MPa and 145 MPa, respectively, with a moderate elongation to failure of 12.4%, and the average micro‐hardness is about 63 HV. At 373 K, high density dislocations induced by CGP are preserved to enhance the strength and micro‐hardness. The cross‐orientation procedure improves the deformation homogeneity and results in strength increase and ductility recovery at the later stages. Increasing temperature weakens the homogeneity improvement and grain refinement with strain accumulation. The β‐Li phase is refined faster than α‐Mg phase, and grain sizes about 1 μm are observed in β‐Li phase. Dynamic recrystallization (DRX) firstly occurs in the soft and ductile β‐Li phase at 423 K. The grain refinement induced by DRX in β‐Li phase is counteracted by grain coarsening in α‐Mg phase, which causes no obvious enhancement of mechanical properties at higher temperatures of 423 K and 473 K.</p><p>This article is protected by copyright. All rights reserved.</p>

materials science, multidisciplinary