Abstract:Laser powder bed fusion (LPBF) uses a focused, high power laser to repeatedly scan geometric patterns on thin layers of metal powder, which build up to a final, solid three-dimensional (3D) part. This process is somewhat limited in that the parts tend to have poorer surface finish (compared to machining or grinding) and distortion due to residual stress, as well as multiple other deficiencies. Typical laser scan strategies are relatively simple and use constant laser power levels. This elicits local variations in the melt pool size, shape, or temperature, particularly near sharp geometric features or overhang structures due to the relatively higher thermal conductivity of solid metal compared to metal powder. In this paper, we present a new laser power control algorithm, which scales the laser power to a value called the geometric conductance factor (GCF). The GCF is calculated based on the amount of solid vs. powder material near the melt pool. The algorithm for calculating GCF is presented along with some basic examples for clarification. Then, we detail the hardware and software implementation on the National Institute of Standards and Technology (NIST) additive manufacturing metrology testbed (AMMT), which includes co-axial melt pool monitoring using a high-speed camera. Six parts were fabricated out of nickel superalloy 625 (IN625) with the same nominal laser power, but with varying GCF algorithm parameters. We demonstrate the effect of tailored laser power on reducing the variability of melt pool intensity measured throughout the 3D build. Finally, we contrast the difference between the 'optimized' part vs. the standard build parameters, including the deflection of the final part top surface near the overhang and the variation of surface finish on the down-facing surfaces. Ultimately, the improvements to the in-situ process monitoring and part qualities demonstrate the utility and future potential tuning and optimizing more complex laser scan strategies.

High-Efficiency Dynamic Scanning Strategy for Powder Bed Fusion by Controlling Temperature Field of the Heat-Affected Zone

A Surface Quality Optimization Strategy Based on a Dedicated Melt-Pool Control Via the Dashed-Scan Contouring Technique in Electron Beam Powder Bed Fusion

Temperature field analysis and process parameter optimization during L-PBF of Al-Mg-Sc-Zr alloy

Numerical and experimental investigation of the geometry dependent layer-wise evolution of temperature during laser powder bed fusion of Ti–6Al–4V

Study of Powder Entrainment in L-PBF Process with Maximum Hatching Space for Higher Process Efficiency

Influence of shielding gas flow consistency on parts quality consistency during large-scale laser powder bed fusion

Influence of beam diameter on Laser Powder Bed Fusion (L-PBF) process

A highly efficient computational approach for fast scan-resolved simulations of metal additive manufacturing processes on the scale of real parts

Processing-microstructure relationships in ferrous alloys via mixed powder laser powder bed fusion

Real-time monitoring of laser powder bed fusion process using high-speed X-ray imaging and diffraction

Online in-situ monitoring of melt pool characteristic based on a single high-speed camera in laser powder bed fusion process

Analytical Modelling of Scanning Strategy Effect on Temperature Field and Melt Track Dimensions in Laser Powder Bed Fusion

Revealing transient powder-gas interaction in laser powder bed fusion process through multi-physics modeling and high-speed synchrotron x-ray imaging

Thermal and dynamic characteristics in the corners of LPBF-fabricated TC4 multi-track parts and the impact of contour scanning

Analysis of preheating temperature field characteristics in selective laser sintering

Process Monitoring Using Synchronized Path Infrared Thermography in PBF-LB/M

Promoting the densification and grain refinement with assistance of static magnetic field in laser powder bed fusion

Part geometry and conduction-based laser power control for powder bed fusion additive manufacturing

Multi-sensor monitoring of powder melting states via melt pool optical emission signals during laser-based powder bed fusion

Area melting with multi-laser arrays to increase build rate for metal powder bed fusion additive manufacturing

Control-Oriented Modeling and Layer-to-Layer Spatial Control of Powder Bed Fusion Processes