Abstract:For the 6063 aluminum alloy spray quenching process, respectively establish finite element model of upper, lower nozzle jet impact and water area and meshing in the Gambit. Import into fluent software for cooling numerical simulation, getting the upper and lower nozzle’s pressure contours , velocity contours , heat transfer coefficient curve and water area’s velocity contours and heat transfer coefficient curves. Analysis the various contours and the heat transfer coefficient along the aluminum plate surface radial distribution: upper nozzle’s heat transfer intensity is not in stationary point and near its both sides; Lower nozzle’s contours and heat transfer coefficient has a certain similarity with the upper nozzle, but the maximum heat transfer intensity is at stagnation point; Water area‘s heat transfer coefficient fall faster at the entrance and maintained at a constant value finally. Put heat transfer coefficient as a boundary condition into the ansys software to simulate the three dimensional temperature field of quenching process and analysis the temperature field contours in different time: the biggest speed is 36°C/s during the process of quenching, appearing in the high temperature range, namely deformation sensitive areas, therefore it most likely to occur deformation at the beginning of the quenching profiles.

Heat transfer coefficient during cooling water of continuous casting of aluminum alloy

A Finite Difference Method for Determining Interdiffusivity of Aluminide Coating Formed on Superalloy

Laboratory Experimental Setup And Research On Heat Transfer Characteristics During Secondary Cooling In Continuous Casting

Equivalent Heat Transfer Coefficient at Casting/Cu Mould Interface and Temperature Field Simulation

A Calculation Model for Cooling Rate of Aluminum Alloy Melts during Continuous Rheo-Extrusion

Experimental study of heat-transfer coefficient of Al-Zn-Mg-Cu ultra-thick hot plate during multi-stage quenching

Method for Determining the Boundary Condition of Heat Transfer in Mold for Slab Casting

Simulation and application of dynamic heat transfer model for improvement of continuous casting process

Applying of Real-time Heat Transfer and Solidification Model on the Dynamic Control System of Billet Continuous Casting

6063 Aluminum Alloy Online Quenching Surface Heat Transfer Coefficient and the Temperature Field Simulation

A Study of the Interfacial Heat Transfer Between an Iron Casting and A Metallic Mould

Numerical Analysis of the Cooling System Performance and Effectiveness in Aluminum Low-Pressure Die Casting

Numerical modeling of the heat treatment with residual heat of aluminum castings

Identification of Convection Heat Transfer Coefficient of Secondary Cooling Zone of CCM based on Least Squares Method and Stochastic Approximation Method

Heat Transfer Coefficient Determination in a Gravity Die Casting Process with Local Air Gap Formation and Contact Pressure Using Experimental Evaluation and Numerical Simulation

An Inverse Estimation of Frozen Sand Mold-Melt Heat Transfer Coefficient in the Solidification of A356 Alloy

Study on Heat Transfer Behavior at Metal/Die Interface in Aluminum Alloy Die Casting Process - I. Experimental Study and Determination of the Interfacial Heat Transfer Coefficient

Numerical Simulation and Experiments Research on Secondary Cooling Process of Thick Slab Continuous Casting

Mathematical Heat Transfer Model Research for the Improvement of Continuous Casting Slab Temperature

STUDY OF INTERFACIAL HEAT TRANSFER COEFFI-CIENT BETWEEN METAL AND DIE DURING HIGH PRESSURE DIE CASTING PROCESS OF ALUMINUM ALLOY ADCl2Z

Finite difference heat-transfer modeling for continuous casting