Abstract:We introduce magnetophoresis-based microfluidics for sorting biological targets using positive Magnetophoresis (pM) for magnetically labeled particles and negative Magnetophoresis (nM) for label-free particles. A single, externally magnetized ferromagnetic wire induces repulsive forces and is positioned across the focused sample flow near the main channel's closed end. We analyze magnetic attributes and separation performance under two transverse dual-mode magnetic configurations, examining magnetic fields, hydrodynamics, and forces on microparticles of varying sizes and properties. In pM, the dual-magnet arrangement (DMA) for sorting three distinct particles shows higher magnetic gradient generation and throughput than the single-magnet arrangement (SMA). In nM, the numerical results for SMA sorting of red blood cells (RBCs), white blood cells (WBCs), and prostate cancer cells (PC3-9) demonstrate superior magnetic properties and throughput compared to DMA. Magnetized wire linear movement is a key design parameter, allowing device customization. An automated device for handling more targets can be created by manipulating magnetophoretic repulsion forces. The transverse wire and magnet arrangement accommodate increased channel depth without sacrificing efficiency, yielding higher throughput than other devices. Experimental validation using soft lithography and 3D printing confirms successful sorting and separation, aligning well with numerical results. This demonstrates the successful sorting and separating of injected particles within a hydrodynamically focused sample in all systems. Both numerical and experimental findings indicate a separation accuracy of 100% across various Reynolds numbers. The primary channel dimensions measure 100 μm in height and 200 μm in width. N52 permanent magnets were employed in both numerical simulations and experiments. For numerical simulations, a remanent flux density of 1.48 T was utilized. In the experimental setup, magnets measuring 0.5 × 0.5 × 0.125 inches and 0.5 × 0.5 × 1 inch were employed. The experimental data confirm the device's capability to achieve 100% separation accuracy at a Reynolds number of 3. However, this study did not explore the potential impact of increased flow rates on separation accuracy.

Label-free separation of nanoscale particles by an ultrahigh gradient magnetic field in a microfluidic device

High-Resolution Separation of Nanoparticles Using a Negative Magnetophoretic Microfluidic System

A Magnetic Field Enhanced Microfluidic Device for Precise Particle Separation

Size-selective Separation of Magnetic Nanospheres in a Microfluidic Channel

Continuous-flow In-Droplet Magnetic Particle Separation in a Droplet-Based Microfluidic Platform

Simultaneous Separation and Washing of Nonmagnetic Particles in an Inertial Ferrofluid/Water Coflow.

Scalable high-throughput microfluidic separation of magnetic microparticles

Microfluidic Separation of Particles by Synergistic Effect of Geometry-Induced Hydrodynamics and Magnetic Field

In Situ Analysis of Capturing Dynamics of Magnetic Nanoparticles in A Microfluidic System

Multiphase Ferrofluid Flows for Micro-Particle Focusing and Separation

Experimental Investigation of Magnetically Actuated Separation Using Tangential Microfluidic Channels and Magnetic Nanoparticles.

Microfluidic Separation of Magnetic Particles with Soft Magnetic Microstructures

Magnetic concentration of particles and cells in ferrofluid flow through a straight microchannel using attracting magnets

Magnetic Nanoparticle Migration in Microfluidic Two-Phase Flow

A High-Gradient Magnetic Separation System for Separating Magnetic Nanobeads from Aqueous Solution

Field-flow Fractionation of Magnetic Particles in a Cyclic Magnetic Field

Microfluidic Co-Flow of Newtonian and Viscoelastic Fluids for High-Resolution Separation of Microparticles.

A magnetophoretic microdevice for multi-magnetic particles separation based on size: a numerical simulation study

Enhanced microfluidic multi-target separation by positive and negative magnetophoresis

Fabrication and Integration of Microscale Permanent Magnets for Particle Separation in Microfluidics

Disaggregation and separation dynamics of magnetic particles in a microfluidic flow under an alternating gradient magnetic field