Abstract:We introduce magnetophoresis-based microfluidics for sorting biological targets using positive Magnetophoresis (pM) for magnetically labeled particles and negative Magnetophoresis (nM) for label-free particles. A single, externally magnetized ferromagnetic wire induces repulsive forces and is positioned across the focused sample flow near the main channel's closed end. We analyze magnetic attributes and separation performance under two transverse dual-mode magnetic configurations, examining magnetic fields, hydrodynamics, and forces on microparticles of varying sizes and properties. In pM, the dual-magnet arrangement (DMA) for sorting three distinct particles shows higher magnetic gradient generation and throughput than the single-magnet arrangement (SMA). In nM, the numerical results for SMA sorting of red blood cells (RBCs), white blood cells (WBCs), and prostate cancer cells (PC3-9) demonstrate superior magnetic properties and throughput compared to DMA. Magnetized wire linear movement is a key design parameter, allowing device customization. An automated device for handling more targets can be created by manipulating magnetophoretic repulsion forces. The transverse wire and magnet arrangement accommodate increased channel depth without sacrificing efficiency, yielding higher throughput than other devices. Experimental validation using soft lithography and 3D printing confirms successful sorting and separation, aligning well with numerical results. This demonstrates the successful sorting and separating of injected particles within a hydrodynamically focused sample in all systems. Both numerical and experimental findings indicate a separation accuracy of 100% across various Reynolds numbers. The primary channel dimensions measure 100 μm in height and 200 μm in width. N52 permanent magnets were employed in both numerical simulations and experiments. For numerical simulations, a remanent flux density of 1.48 T was utilized. In the experimental setup, magnets measuring 0.5 × 0.5 × 0.125 inches and 0.5 × 0.5 × 1 inch were employed. The experimental data confirm the device's capability to achieve 100% separation accuracy at a Reynolds number of 3. However, this study did not explore the potential impact of increased flow rates on separation accuracy.

Three-dimensional numerical analysis of focusing and separation of diamagnetic particles in ferrofluid

Multiphase Ferrofluid Flows for Micro-Particle Focusing and Separation

Three-dimensional magnetic focusing of particles and cells in ferrofluid flow through a straight microchannel

Magnetic concentration of particles and cells in ferrofluid flow through a straight microchannel using attracting magnets

A magnetophoretic microdevice for multi-magnetic particles separation based on size: a numerical simulation study

Design and Development of a Traveling Wave Ferro-Microfluidic Device and System Rig for Potential Magnetophoretic Cell Separation and Sorting in a Water-Based Ferrofluid

Magnetic field effect on the sedimentation process of two non-magnetic particles inside a ferrofluid

Numerical analysis of microfluidic magnetic bead separation utilizing an integrated array of magnetic elements magnetized by a homogenous bias field

Magnetophoresis of Nonmagnetic Particles in Ferrofluids

Enhanced microfluidic multi-target separation by positive and negative magnetophoresis

Magnetophoresis of ferrofluid in microchannel system and its nonlinear effect

Size-selective Separation of Magnetic Nanospheres in a Microfluidic Channel

Collaborative design : managing task interdependencies and multiple perspectives

Microfluidic Separation of Magnetic Particles with Soft Magnetic Microstructures

Magnetic field-induced interfacial pattern formation in thin ferrofluid drops

Ferrofluids and magnetically guided superparamagnetic particles in flows: a review of simulations and modeling

Numerical analysis of magnetic nanoparticle transport in microfluidic systems under the influence of permanent magnets

A magnetic field coupling lattice Boltzmann model and its application on the merging process of multiple-ferrofluid-droplet system

Fabrication and Integration of Microscale Permanent Magnets for Particle Separation in Microfluidics

Efficient numerical modelling of magnetophoresis in millifluidic systems

In Situ Analysis of Capturing Dynamics of Magnetic Nanoparticles in A Microfluidic System