Abstract:Control of low-concentration pollutants from a semiconductor process vent stream using a wet-scrubbing technique is a challenging task to meet Taiwan environmental emission standards. An efficient wet-scrubber is designed on a pilot scale and tested to control low concentration acid and base waste-gas emission. The scrubber system consisted of two columns, i.e., a fine spray column [cutoff diameter (based on volume), Dv(50) = 15.63 microm; Sauter mean diameter (SMD) = 7.62 microm], which is especially efficient for NH3 removal as the pH of the spraying liquid is approximately 7 followed by a packed column with a scrubbing liquid pH approximately 9.0 mainly for acids removal. It is observed that use of the surfactants in low concentration about 10(-4) M and 10(-7) M in the spray liquid and in the scrubbing liquid, respectively, remarkably enhances the removal efficiency of the system. A traditional packed column (without the spray column and the surfactant) showed that the removal efficiencies of NH3, HF, and HCl for the inlet concentration range 0.2 to 3 ppm were (n = 5) 22.6+/-3.4%, 43.4+/-5.5%, and 40.4+/-7.4%, respectively. The overall efficiencies of the proposed system (the spray column and the packed column) in the presence of the surfactant in the spray liquid and in the scrubbing liquid forthese three species were found to increase significantly (n = 5) from 60.3+/-3.6 to 82.8+/-6.8%, 59.1+/-2.7 to 83.4+/-4.2%, and 56.2+/-7.3 to 81.0+/-6.7%, respectively. In this work, development of charge on the gas-liquid interface due to the surfactants has been measured and discussed. It is concluded that the presence of charge on the gas-liquid interface is the responsible factor for enhancement of the removal efficiency (mass-transfer in liquid phase). The effects of the type of surfactants, their chain length, concentration in liquid, etc. on the removal efficiency are discussed. Since the pilot tests were performed under the operating conditions similar to most of the wet-scrubbers operated in semiconductors manufacturing facilities for inorganic pollutants, this study can be applied to modify the existing wet-scrubbers to enhance the removal efficiencies, especially for low-concentration pollutants.

Emission and local ventilation control of droplets generated by condensation and bubble-bursting during pickling

Fog Droplet Collection by Corona Discharge in a Needle-Cylinder Electrostatic Precipitator with a Water Cooling System

Distribution and removal efficiency of sulfuric droplets under two general ventilation modes

Applicability of vapor pressure models on the prediction of evaporation and motion of sulfuric and hydrochloric droplets in free-falling process

Acid Emission Automatic Real-Time Sampling Monitoring System

Agglomeration and Capture of Fine Particles in the Coupling Effect of Pulsed Corona Discharge and Acoustic Wave Enhanced by Spray Droplets

Acid recovering and iron recycling from pickling waste acid by extraction and spray pyrolysis techniques

Efficient control system for low-concentration inorganic gases from a process vent stream: application of surfactants in spray and packed columns

Emission and purification of evaporated–condensed oil droplets affected by condensation nuclei during machining

Electric charge effect of micro-droplets generated by electrospray atomization on removal of indoor fine particulate matter

Composition and Hygroscopicity of Aerosol Particles at Mt. Lu in South China: Implications for Acid Precipitation

Performance of Constant Exhaust Ventilation for Removal of Transient High-Temperature Contaminated Airflows and Ventilation-Performance Comparison Between Two Local Exhaust Hoods

Highly efficient removal of sulfuric acid aerosol by a combined wet electrostatic precipitator

Study on Determination Method of Nitric Acid Mist in Exhaust Gas from Stationary Source

Field investigation of pollutant characteristics and targeted ventilation control strategies in high-ceiling aircraft spraying workshop

Source and characteristics of inorganic acidic gases and aerosols emission in a semiconductor plant

Preventing Aerosol Emissions in a CO2 Capture System: Combining Aerosol Formation Inhibition and Wet Electrostatic Precipitation

Particle emissions from submerged combustion evaporation of membrane-concentrated leachate

Reduced-scale Experimental Investigation on Ventilation Performance of a Local Exhaust Hood in an Industrial Plant

A study of influence of acoustic excitation on carbon dioxide capture by a droplet

Promoting the synergistic removal of SO 3 aerosols and particles during the flue gas condensation by combining alkali spray and turbulent agglomeration