Abstract:The most commonly reported control used to minimize workplace exposures to nanomaterials is the chemical fume hood. Studies have shown, however, that significant releases of nanoparticles can occur when materials are handled inside fume hoods. This study evaluated the performance of a new commercially available nano fume hood using three different test protocols. Tracer gas, tracer nanoparticle, and nanopowder handling protocols were used to evaluate the hood. A static test procedure using tracer gas (sulfur hexafluoride) and nanoparticles as well as an active test using an operator handling nanoalumina were conducted. A commercially available particle generator was used to produce sodium chloride tracer nanoparticles. Containment effectiveness was evaluated by sampling both in the breathing zone (BZ) of a mannequin and operator as well as across the hood opening. These containment tests were conducted across a range of hood face velocities (60, 80, and 100 ft/min) and with the room ventilation system turned off and on. For the tracer gas and tracer nanoparticle tests, leakage was much more prominent on the left side of the hood (closest to the room supply air diffuser) although some leakage was noted on the right side and in the BZ sample locations. During the tracer gas and tracer nanoparticle tests, leakage was primarily noted when the room air conditioner was on for both the low and medium hood exhaust airflows. When the room air conditioner was turned off, the static tracer gas tests showed good containment across most test conditions. The tracer gas and nanoparticle test results were well correlated showing hood leakage under the same conditions and at the same sample locations. The impact of a room air conditioner was demonstrated with containment being adversely impacted during the use of room air ventilation. The tracer nanoparticle approach is a simple method requiring minimal setup and instrumentation. However, the method requires the reduction in background concentrations to allow for increased sensitivity.

Performance of Constant Exhaust Ventilation for Removal of Transient High-Temperature Contaminated Airflows and Ventilation-Performance Comparison Between Two Local Exhaust Hoods

Reduced-scale Experimental Investigation on Ventilation Performance of a Local Exhaust Hood in an Industrial Plant

Numerical Comparison of the Efficiency of Mixing Ventilation and Impinging Jet Ventilation for Exhaled Particle Removal in a Model Intensive Care Unit

Performance Analysis of Range Hoods with Different Exhaust Air Volumes

Capture and Containment Efficiency of the Exhaust Hood in A Typical Chinese Commercial Kitchen with Air Curtain Ventilation

Performance study of a new type of collection equipment for unorganized fumes from aluminum electrolysis

Research on a push-pull industrial trough-side exhaust hood based on CFD simulation and experiment

Using the principle of dynamic temporal separation to determine the range hood direct capture efficiency

Intelligent Simulation Experimental Study on Influence of Air Velocity of Air Supply Hood and Exhaust Hood with Vertical Push-Pull Ventilation.

Prediction of Transient Contaminant Dispersion and Ventilation Performance Using the Concept of Accessibility

Flow-field characteristics and ventilation performance of the high-temperature buoyant jet controlled by spray-local exhaust ventilation

Comprehensive Performance Evaluation of a Novel Aaberg Exhaust System Reinforced by a Swirling Jet

Decoupling transient effects of factors affected by air recirculation devices on contaminant distribution in ventilated spaces

Numerical study on the effect of buoyancy-driven pollution source on vortex ventilation performance

Performance of novel overhead crane fume-collecting hood for pollutant removal

Effects of Window Position and Exhaust Flow Rate on Residential Kitchen Hood Performance: A Validated Numerical Approach

Evaluation of Leakage From Fume Hoods Using Tracer Gas, Tracer Nanoparticles and Nanopowder Handling Test Methodologies

Removing painting-generated VOCs in a commercial airplane hangar with multiple portable exhaust hoods

Optimizing the Range Hood Airflow Rate to Improve the Kitchen Environment and Reduce Energy Consumption

Performance of three air distribution systems in VOC removal from an area source

Experimental and theoretical investigation on transportation of gaseous pollutants in long and narrow industrial buildings