Abstract:This paper proposes a novel approach for monitoring multi-bolt looseness using guided waves and the cross-correlation of the wavelet energy envelope. By assessing variations in the wave packet, the looseness in multi-bolt assemblies can be estimated. First, the dispersion effects of Lamb waves were theoretically analyzed using the Rayleigh-Lamb equation. Next, the wavelet energy was derived through wavelet transform, and the Lamb wave envelope was obtained as a criterion for accurately separating the wave packet. Cross-correlation analysis was employed to quantitatively evaluate the dispersion of wave packets for varying levels of bolt looseness. A looseness index, termed the normalized decorrelation coefficient of wavelet energy (NDCWE), was defined. Then, validation experiments were conducted using a joint with five M8 bolts, each tightened to a standard torque of 42 N·m. Two piezoelectric transducers were attached to the periphery of the bolt group. Three preload conditions were tested for each bolt: fully tightened, 80% of the standard torque, and 10% of the standard torque, corresponding to no looseness (NL), minor looseness (ML), and significant looseness (SL), respectively. Results showed that when significant looseness occurs, the NDCWE value exceeds 0.4, confirming the effectiveness of NDCWE in detecting substantial reductions in bolt preload. Experiments assessing the effect of temperature revealed that temperature has a negligible effect on the waveforms of the S0 and A0 mode waves. Finally, to quantitatively evaluate the efficiency of the ultrasonic transducers, the bolt-to-sensor ratio (BSR) was introduced. In this study, the BSR reached 2.5, indicating that a single piezoelectric transducer can monitor the preload of 2.5 bolts. The proposed approach shows great potential for multi-bolt looseness monitoring.

Monitoring the looseness of a bolt through laser ultrasonic

Bolt Looseness Detection Using SH Guided Wave and Wave Energy Transmission

Multi-bolt looseness monitoring using guided waves: a cross-correlation approach of the wavelet energy envelope

Bolt Loosening Detection Based on Piezoelectric Active Sensing Technology*

Bolt tightness monitoring using multiple reconstructed narrowband lamb waves combined with piezoelectric ultrasonic transducer

A piezoelectric active sensing method for quantitative monitoring of bolt loosening using energy dissipation caused by tangential damping based on the fractal contact theory

Noncontact measurement of bolt axial force in tightening processes using scattered laser ultrasonic waves

Electromechanical impedance instrumented wearable piezoelectric ring-type sensor for bolted connection monitoring

Real time bolt preload monitoring using piezoceramic transducers and time reversal technique—a numerical study with experimental verification

Application of Ultrasonic Stress Measurement in the Evaluation of Bolt Fastening Force

Study on the effect mechanism of vibration excitation parameters on bolt loosening based on an implicit monitoring method

Research on the Measurement Technology for Pretension Stress on Small-Sized Bolts Based on the Piezoelectric Ultrasonic Resonance Method

A bolt preload monitoring method based on the refocusing capability of virtual time reversal

Axial stress measurement for tightened bolt based on the effect of stress on ultrasonic wave attenuation

Preload Monitoring of Bolted L-Shaped Lap Joints Using Virtual Time Reversal Method

Application of subharmonic resonance for the detection of bolted joint looseness

Vibration acoustic modulation for bolt looseness monitoring based on frequency-swept excitation and bispectrum

A Review of Bolt Tightening Force Measurement and Loosening Detection

Theoretical and experimental study on FBG bending sensor for quantitative monitoring of bolt looseness

Multi-Bolt Loosening Monitoring Using an Integrated Vibro-Acoustic Modulation Technique