Abstract:Ni-rich LiNixMnyCo1-x-yO2 (NMC, x ≥ 0.5) cathode materials have attracted intensive attention in developing high energy-density lithium ion batteries, owing to their high capacity and relatively low cost. Among them, LiNi0.8Mn0.1Co0.1O2 (NMC811) is one of the most promising candidates to realize higher energy density, particularly operating at high cut-off voltage (e.g. 4.5 V vs. Li/Li+). However, the limited cycle life is becoming the plague for its practical application due to the structural instability, microcracks formation, and electrolyte decomposition at the electrode/electrolyte interface.[1,2] As well known, single crystal NMC materials have more stable surface activity because of the low surface area and better mechanical stability than conventional polycrystalline materials. Moreover, single crystalline NMC materials can provide not only high gravimetric energy density, but also high volumetric energy density due to the increased tap density compared to the conventional polycrystalline NMC materials.[2-4]In this study, a single crystalline NMC811 sample with a large particle size of around 5 μm and polyhedral shape was synthesized by sol-gel method. Furthermore, a homogeneous ultrathin surface coating layer (~2 nm) was built on the surface of the single crystalline NMC811 particles to act as protective layer to prevent the direct contact between electrolyte and active particles. As a result, the coating layer effectively enhances an overall electrochemical performance of single crystalline NMC811 materials and especially leads to a higher reversible capacity as well as a remarkable improvement of the capacity retention (90% after 200 cycles between 3 and 4.5 V vs. Li/Li+). The influences of the coating layer on the structure and interfacial stability and electrochemical properties will be presented in details later. References: [1] H. Y. Li, J. Li, X. W. Ma.J. R. Dahn. J. Electrochem. Soc. 2018, 165, A1038-A1045. [2] J. Kim, H. Lee, H. Cha, M. Yoon, M. Park, J. Cho. Adv. Energy Mater. 2018, 8, 1702028. [3] H. D. Liu, R. Kloepsch, J. Wang, M. Winter.J. Li. J. Power Sources 2015, 300, 430-437. [4] H. D. Liu, J. Wang, X. F. Zhang, D. Zhou, X. Qi, B. Qiu, J. H. Fang, R. Kloepsch, G. Schumacher, Z. P. Liu et al. ACS Appl. Mater. Interfaces 2016, 8 (7), 4661-4675. Figure 1

Enhanced structure and electrochemical stability of single crystal nickel-rich cathode material by La2Li0.5Co0.5O4 surface coating

Radially Oriented Single‐Crystal Primary Nanosheets Enable Ultrahigh Rate and Cycling Properties of LiNi0.8Co0.1Mn0.1O2 Cathode Material for Lithium‐Ion Batteries

Surface Atomic Rearrangement with High Cation Ordering for Ultra-Stable Single-Crystal Ni-Rich Co-Less Cathode Materials

One-Step Synthesis of a Single-Crystal LiNi 0.83 Co 0.11 Mn 0.06 O 2 Cathode with Excellent Electrochemical Properties by Ti 4+ Doping and LiTi 2 O 4 In Situ Chemical Coating Using a Novel Variable Temperature Sintering Process

Surface Cobaltization for Boosted Kinetics and Excellent Stability of Nickel-rich Layered Cathodes

The cycle performance of high nickel cathode materials significantly enhanced by the LiAlO2@Al2O3 dual-modified coating

An integrated surface coating strategy to enhance the electrochemical performance of nickel-rich layered cathodes

Dual-Element-Modified Single-Crystal LiNi0.6Co0.2Mn0.2O2 As a Highly Stable Cathode for Lithium-Ion Batteries.

Suppressed Internal Intrinsic Stress Engineering in High‐performance Ni‐rich Cathode via Multilayered In‐situ coating Structure

Synthesis of Single Crystalline Ni-Rich NMC811 Cathode Materials and Improved Performance Enabled By Ultrathin Surface Coating Layer

Optimized structure stability and cycling performance of LiNi0.8Co0.1Mn0.1O2 through homogeneous nano-thickness Al2O3 coating

Elevating cycle stability of Ni-rich NCM811 cathode via single-crystallization integrating dual-modification strategy for lithium-ion batteries

Synergistic Effect of B-Nb Co-modified to Achieve Crystal Structure and Interface Tuning for Ni-rich Cathode

Protective and ion conductive: High-Rate Ni-Rich cathode with enhanced cyclic stability via One-Step bifunctional dual-layer coating

Enhanced cycling stability of single-crystal LiNi0.83Co0.07Mn0.10O2 by Li-reactive coating with H3BO3

Sol/Antisolvent Coating for High Initial Coulombic Efficiency and Ultra-stable Mechanical Integrity of Ni-Rich Cathode Materials

Electrochemical performances of nickel‐rich single‐crystal LiNi0.83Co0.12Mn0.05O2 cathode material synthesized by tuning Li+/Ni2+ mixing

Dual-Element-Modified Single-Crystal LiNi 0.6 Co 0.2 Mn 0.2 O 2 as a Highly Stable Cathode for Lithium-Ion Batteries

Enhancing high-voltage structural stability of single-crystalline Ni-rich LiNi0.9Mn0.05Co0.05O2 cathode material by ultrathin Li-rich oxide layer for lithium-ion batteries

Investigation of Li 3 PO 4 Coating and Nb 5+ Doping Effect on the Crystal Structure and Electrochemical Properties of Ni-Rich LiNi 0.85 Co 0.05 Mn 0.10 O 2 Cathode

Double Conductor Coating to Improve the Structural Stability and Electrochemical Performance of LiNi 0.8 Co 0.1 Mn 0.1 O 2 Cathode Material