Abstract:An axial flow fan, which is applied for ventilation in underground spaces such as tunnels, features a medium–large size, and most of the blades go through the casting process in consideration of mass production and cost. In the casting process, post-work related to roughness treatment is essential, and this is a final operation to determine the thickness profile of an airfoil which is designed from the empirical equation. In this study, the effect of the thickness profile of an airfoil on the performance and aerodynamic characteristics of the axial fan was examined through numerical analysis with the commercial code, ANSYS CFX. In order to conduct the sensitivity analysis on the effect of the maximum thickness position for each span on the performance at the design flow rate, the design of experiments (DOE) method was applied with a full factorial design as an additional attempt. The energy loss near the shroud span was confirmed with a quantified value for the tip leakage flow (TLF) rate through the tip clearance, and the trajectory of the TLF was observed on the two-dimensional (2D) coordinates system. The trajectory of the TLF matched well with the tendency of the calculated angle and correlated with the intensity of the turbulence kinetic energy (TKE) distribution. However, a correlation between the TLF rate and TKE could not be established. Meanwhile, the Q-criterion method was applied to specifically initiate the distribution of flow separation and inlet recirculation. The location accompanying the energy loss was mutually confirmed with the axial coordinates. Additionally, the nonuniform blade loading distribution, which was more severe as the maximum thickness position moved toward the leading edge (LE), could be improved significantly as the thickness near the trailing edge (TE) became thinner. The validation for the numerical analysis results was performed through a model-sized experimental test.

Aerodynamics of a partial shrouded low-speed axial flow fan

Effect of tip geometry on the performance of low-speed axial flow fan

Effect of Meridional Shape on Performance of Axial-Flow Fan

Investigation study on the flow-induced noise by winglet and shroud shape of an axial flow fan at an outdoor unit of air conditioner

Influence of Tip Clearance on Performance of A Contra-Rotating Fan

Shroud depth structure of multi-fans cooling package

Numerical Investigation on the Aerodynamic and Aeroacoustic Characteristics in New Energy Vehicle Cooling Fan with Shroud

Experimental and Numerical Study of Cross-flow Fan in Air-conditioner Indoor Unit

Numerical Investigation of Performance and Flow Characteristics of a Tunnel Ventilation Axial Fan with Thickness Profile Treatments of NACA Airfoil

Numerical and experimental investigation into effects of winglet shape on flow and noise performances of axial-flow fans for outdoor unit of air conditioner

Flow physics and loss mechanisms of tip leakage flow in variable-blade-pitch-angle ducted fans

The matching characteristics and flow mechanisms of partial-height booster rotor and fan rotor for a high-throughflow fan

High-frequency unsteady flow near the tip in a transonic fan rotor with a small clearance

Investigation of varying tip clearance gap and operating conditions on the fulfilment of low-speed axial flow fan

Numerical investigation of the aerodynamic performance and loss mechanism in a low bypass ratio variable cycle engine fan

Numerical Research On Effects Of Shroud Contraction On Tip Leakage Flow And Overall Performance Of Axial Compressors

Enhancing Axial Flow Fan Performance in Air-Cooled Condensers: Tip Vortex Manipulators and Comparative Analysis of Numerical Simulation and Experimental Testing

Diagnosis and Design Improvement of the Internal Flow Field in an Automotive Cooling Fan Based on Boundary Vorticity Dynamics, Part I: Blade Profile Scaling and Rotation

Cooling fan aerodynamic noise reduction with short inlet duct and its applicability

AErodynamic Noise Characteristics Of Axial Flow Fan In Narrow Space And Noise Reduction Based On Flow Control

Noise Reduction Analysis of Electronic Device Cooling Fan With Duct and Its Application Under Variable Working Conditions