Abstract:Abstract Direct dry-cooled power plants typically operate numerous large-diameter axial flow fans in air-cooled condensers (ACCs) to facilitate the condensation of steam in the plant's thermodynamic cycle. Enhanced fan efficiency may, at scale, lead to significant parasitic power reductions and subsequent increases in plant power output. The performance of these fans may be increased by adding blade tip modifications which act to control blade tip leakage flow. Previous studies have shown that manipulating the tip leakage vortex increases the blade-to-air momentum transfer and stabilizes the air flow structures as it traverses the fan blade. This paper takes a step towards the development of improved tip vortex manipulators for an ACC fan. Three-dimensional computational fluid dynamic (CFD) simulations, and experimental testing of the modified and unmodified fan within an ISO test facility is performed. The results are then utilized to assess the accuracy of the simulation model, visualize the manipulated flow structures at the blade tip, and ultimately quantify the effect of the endplate designs on fan performance. Excellent correlation between numerical and test results for the unmodified fan is observed, and the benefit of blade tip modification on fan performance is again confirmed experimentally. The simulation model however fails to predict improvements in fan performance under modification, and simulated tip leakage flows are investigated for clarification. It is hypothesized that deflection of tip endplates under operation account for differences between simulation and experiment, and that fluid-structure interaction analyses could potentially resolve discrepancies.

Enhancing Axial Flow Fan Performance in Air-Cooled Condensers: Tip Vortex Manipulators and Comparative Analysis of Numerical Simulation and Experimental Testing

Enhancing Axial Flow Fan Performance in Air-Cooled Condensers: Tip Vortex Manipulators and Comparative Analysis of Numerical Simulation and Experimental Testing

Optimization Design of Centrifugal Fan Impeller Based on Numerical Simulation.

Axial flow fan performance in a forced draught air-cooled heat exchanger for a sCO2 Brayton cycle

Numerical Investigation on Mechanism and Modeling of Tip Leakage Flow Loss in Partially Shrouded Axial Flow Fans

Effect of tip geometry on the performance of low-speed axial flow fan

Experimental Investigation of Tip Clearance Flows of an Axial Flow Fan Using PDA

Diagnosis and Design Improvement of the Internal Flow Field in an Automotive Cooling Fan Based on Boundary Vorticity Dynamics, Part I: Blade Profile Scaling and Rotation

Design of Sinusoidal Leading Edge for Low-Speed Axial Fans Operating under Inflow Distortion

Experimental and Computational Investigation of the Tip Clearance Flow for an Axial Ventilation Fan

Investigation of varying tip clearance gap and operating conditions on the fulfilment of low-speed axial flow fan

Experimental Investigation of the Tip Clearance Flow for an Axial Flow Fan Rotor Using a PIV System

Experimental noise reduction (aeroacoustical enhancement) of a large diameter axial flow cooling fan through a reduction in blade tip clearance

Experimental Study on the Tip Leakage Flow of an Axial Fan

Improvement of Fan Design Using CFD

Influence from the Blade Installation Angle of the Windward Axial Fans on the Performance of an Air-Cooled Power Plant

Numerical Investigation on the Influences of Boundary Layer Ingestion on Tip Leakage Flow Structures and Losses in a Transonic Axial-Flow Fan

EXPERIMENTAL INVESTIGATION OF TIP CLEARANCE FLOW FOR AN AXIAL FLOW FAN ROTOR

Numerical and Experimental Investigation of Flow Behaviour and Aerodynamic Noise in Axial Flow Fan of Air-Conditioner

Influence of Tip Clearance on Performance of A Contra-Rotating Fan

Experimental and Numerical Investigation of the Flow Field in the Tip Region of an Axial Ventilation Fan