Abstract:There is a vast amount of globally underutilized low-grade mine tailings and leach residues, including those from primary processing of gold. In this research, the target is to recover the remaining gold (10.9 g/t) from weathered refractory iron-rich residue that had previously been subject to autoclave oxidation, subsequent cyanidation in a conventional carbon-in-leach (CIL) circuit as well as storage at tailings area. Chloride leaching has been considered as one of the most promising cyanide-free gold leaching methods and it has shown positive outcomes in treating primary gold ores, concentrates, and flotation tailings. Therefore, in the current study, the iron-rich residue investigated was subjected to chloride leaching combined with simultaneous carbon adsorption. The investigated parameters included leaching time (2–8 h), chloride concentration ( [Cl − ] = 0.2–5 M), type and concentration of oxidant ( [Cu 2+ ]/[Fe 3+ ] = 0.1–1 M), as well as type and concentration of activated carbon (14–25 g/L), whereas S/L ratio (100 g/L), acidity ( pH = 1), and temperature (90 °C) were kept constant. Leaching results indicate that up to 40% of the remaining gold could still be recovered from the investigated residue with optimized chloride leaching. According to the results, the most important parameter for gold recovery was the leaching time. Moreover, of the studied oxidants, cupric ions were shown to contribute more to gold recovery when compared to ferric ions (35% vs. 24% at [Cu 2+ ]/[Fe 3+ ] = 0.1 M). Nevertheless, an increase of cupric concentration from 0.1 M (low-concentrated) to 0.5 M, resulted in only a slight increase in gold recovery (from 36% to 40%), whereas no further improvement in gold recovery was achieved with a 1 M cupric concentration. Two studied activated carbon products showed equal effectiveness in gold adsorption. In-situ carbon adsorption was shown to occur effectively in chloride media, as all dissolved gold could be detected in the activated carbon, and the concentration of remaining gold in the pregnant leach solution was minimal (< 0.02 mg/L). These findings indicate that low-concentrated chloride leaching of leach residues from industrial gold processes can allow an enhanced recovery of gold from previously mined and treated raw materials.

The Recovery of Gold from a Copper-Rich Zimbabwean Gold Ore by Cold Stripping

Gold recovery from cyanidation residue by chloride leaching and carbon adsorption – Preliminary results from CICL process

The Recovery of Gold in Low-Grade Cyanide Tailings by Chlorination Roasting

Reagent Elution Combined with Positive Pressure Filtration: A Zero-Discharge Method for Cyanide Tailings Remediation

RECOVERY OF Cu, Zn AND CYANIDE FROM STRONG COPPER CYANIDE SOLUTIONS BY ELFETROWINNING-PARTIAL ACIDIZING

Facile and Novel Method for the Recovery of Gold from a Calcined Concentrate Via Copper–ammonia -Thiourea System and Activated Carbon

Recovery of valuable metals from mining and mineral processing waste

Recovery of copper as CuS from artisanal gold smelting wastewater via sulfide precipitation and its utilization as an H2O2-based AOP catalyst

Extraction of Gold from Tailings Using Ethaline Deep Eutectic Solvent

Experimental Study on Efficient Recovery of High-Grade Sulfide Ore

Enhanced Hydrometallurgical Pretreatment of Micro-disseminated Gold Ore

The Effects of Coexisting Copper, Iron, Cobalt, Nickel, and Zinc Ions on Gold Recovery by Enhanced Cementation via Galvanic Interactions between Zero-Valent Aluminum and Activated Carbon in Ammonium Thiosulfate Systems

Characterizing low-grade refractory gold ores using automated mineralogy coupled with LA ICP-MS

Recycling of residual valuable metals in cyanide-leached gold wastewater using the N263-TBP system

Investigation of glycine leaching for gold extraction from Witwatersrand gold mine tailings with permanganate pre-treatment

GOLD RECOVERY FROM WASTE PRINTED CIRCUIT BOARD IODIDE LEACHATES USING A NOVEL MEMBRANE-BASED ELECTROWINING PROCESS

Characteristics of Gold Minerals in Gold Concentrate with a High Copper Content and Effective Gold Recovery via Flotation and Ammonia Pretreatment–Cyanidation Leaching

Copper Anode Slime Processing with a Focus on Gold Recovery: A Review of Traditional and Recent Technologies

Integrated methods for gold leaching and recovery from ore and electronic waste

Choice of a Sorbent for Copper and Cobalt Sorption from Gold-Containing Heap Leaching Solutions

Eco-friendly and reagent recyclable gold extraction by iodination leaching-electrodeposition recovery