Abstract:There is a vast amount of globally underutilized low-grade mine tailings and leach residues, including those from primary processing of gold. In this research, the target is to recover the remaining gold (10.9 g/t) from weathered refractory iron-rich residue that had previously been subject to autoclave oxidation, subsequent cyanidation in a conventional carbon-in-leach (CIL) circuit as well as storage at tailings area. Chloride leaching has been considered as one of the most promising cyanide-free gold leaching methods and it has shown positive outcomes in treating primary gold ores, concentrates, and flotation tailings. Therefore, in the current study, the iron-rich residue investigated was subjected to chloride leaching combined with simultaneous carbon adsorption. The investigated parameters included leaching time (2–8 h), chloride concentration ( [Cl − ] = 0.2–5 M), type and concentration of oxidant ( [Cu 2+ ]/[Fe 3+ ] = 0.1–1 M), as well as type and concentration of activated carbon (14–25 g/L), whereas S/L ratio (100 g/L), acidity ( pH = 1), and temperature (90 °C) were kept constant. Leaching results indicate that up to 40% of the remaining gold could still be recovered from the investigated residue with optimized chloride leaching. According to the results, the most important parameter for gold recovery was the leaching time. Moreover, of the studied oxidants, cupric ions were shown to contribute more to gold recovery when compared to ferric ions (35% vs. 24% at [Cu 2+ ]/[Fe 3+ ] = 0.1 M). Nevertheless, an increase of cupric concentration from 0.1 M (low-concentrated) to 0.5 M, resulted in only a slight increase in gold recovery (from 36% to 40%), whereas no further improvement in gold recovery was achieved with a 1 M cupric concentration. Two studied activated carbon products showed equal effectiveness in gold adsorption. In-situ carbon adsorption was shown to occur effectively in chloride media, as all dissolved gold could be detected in the activated carbon, and the concentration of remaining gold in the pregnant leach solution was minimal (< 0.02 mg/L). These findings indicate that low-concentrated chloride leaching of leach residues from industrial gold processes can allow an enhanced recovery of gold from previously mined and treated raw materials.

Investigation of glycine leaching for gold extraction from Witwatersrand gold mine tailings with permanganate pre-treatment

Extraction of Gold from Tailings Using Ethaline Deep Eutectic Solvent

Reagent Elution Combined with Positive Pressure Filtration: A Zero-Discharge Method for Cyanide Tailings Remediation

Sustainable and effective gold(I) separation from aurocyanides wastewater and its mechanism using guanidinium ionic liquids

Investigation of old waste dump composition of lean gold-bearing ores from the Golden Pride Project (GPP) mining operation in Nzega district, Tanzania

Synergistic detoxification by combined reagents and safe filling utilization of cyanide tailings

Enhanced Hydrometallurgical Pretreatment of Micro-disseminated Gold Ore

Efficient and stable leaching of gold in a novel ethydiaminedhephen acetic-thiosulfate system

Gold Leaching from Printed Circuit Boards Using a Novel Synergistic Effect of Glycine and Thiosulfate

Gold recovery from cyanidation residue by chloride leaching and carbon adsorption – Preliminary results from CICL process

Enhancing the efficiency of metals extraction from waste lithium-ion batteries through glycine leaching using response surface methodology for economic feasibility

Granular polyacrylonitrile with internal 3D channels for gold recovery from thiosulfate solution

Characterizing low-grade refractory gold ores using automated mineralogy coupled with LA ICP-MS

Potential Uses of Artisanal Gold Mine Tailings, with an Emphasis on the Role of Centrifugal Separation Technique

Interfacial properties of mercaptopropyl-functionalised silica gel and its adsorption performance in the recovery of gold(I) thiosulfate complex

Optimization of the Synergy Between Reduction Leaching of Manganese Anode Slime and Oxidation Pretreatment of Refractory Gold Ore by Response Surface Methodology

Study on Pre-oxidation of a High-Arsenic and High-Sulfur Refractory Gold Concentrate with Potassium Permanganate and Hydrogen Peroxide

Sustainable processing of gold cyanide tailings: Reduction roasting, mechanical activation, non-cyanide leaching, and magnetic separation

Lead Oxide Enhances the Leaching of Gold in Cyanide Tailings

The Recovery of Gold from a Copper-Rich Zimbabwean Gold Ore by Cold Stripping

Extraction and Separation of Gold (I) Cyanide in Polyethylene Glycol-Based Aqueous Biphasic Systems