Abstract:Despite the fact that many tribological components are designed to operate with a comparatively thick film of lubricant, the bearing surfaces often still deteriorate with time as hard particulate contaminants are swept through the bearing gap. These may arise from the external environment or, perhaps, be wear debris from other pairs of surfaces lubricated by the same fluid. In order to investigate this phenomenon experimentally it is necessary to develop a predictable hydrodynamic film between the test surfaces which can be contaminated by small volumes of carefully graded abrasive particles. Here we describe the use of a foil bearing to generate such films between 10 and 50 μm thick to which contaminants such as powdered quartz or finely divided diamond can be added. As the ratio of the characteristic particle size to film thickness is varied not only do the wear rates of the solid surfaces change but examination of the wear tracks suggests that very different mechanisms of material loss come into operation. When the size ratio is low the worn surface of the cylinder is covered by what appears to be small erosion pits; these display virtually no alignment in the direction of relative sliding and it seems that the particles tumble and roll freely through the gap. Above some critical value of the ratio the appearance of the surface changes dramatically to a grooved or micro-machined surface with all the grooves aligned in the sliding direction. A relatively simple theoretical model is developed, based on what happens to a typical particle, which goes some way to explaining these observations. As well as being consistent with the observed transition from “tumbling” to “grooving”, the model can also explain why increasing the hardness differential between the hard and the soft surfaces does not always lead to a reduction in damage to the harder member of the pair.

Creation and evolution of roughness on silica under unlubricated wear

Roughness evolution induced by third-body wear

Effect of wear particles and roughness on nanoscale friction

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Adhesive Wear Regimes on Rough Surfaces and Interaction of Micro-contacts

Mechanisms of abrasive wear in lubricated contacts

Atomistic understanding of rough surface on the interfacial friction behavior during the chemical mechanical polishing process of diamond

Evolution of Bi-Gaussian Surface Parameters of Silicon-Carbide and Carbon-Graphite Discs in a Dry Sliding Wear Process

Transition of frictional states and surface roughness effects in lubricated contacts

The Bi-Gaussian Theory to Understand Sliding Wear and Friction

In-Situ Observation and Study of the Unlubricated Wear Process

Characterization of the Nonuniform Friction Behaviors in Rough Surfaces for the Initial Slip by the Micro-Contact and Deformation Zones

Unraveling the Friction Evolution Mechanism of Diamond‐Like Carbon Film during Nanoscale Running‐In Process toward Superlubricity

Adhesive wear mechanisms in the presence of weak interfaces: Insights from an amorphous model system

The Relationship between Cyclic Multi-Scale Self-Organized Processes and Wear-Induced Surface Phenomena under Severe Tribological Conditions Associated with Buildup Edge Formation

Mechanisms of near-surface structural evolution in nanocrystalline materials during sliding contact

A parameter-free mechanistic model of the adhesive wear process of rough surfaces in sliding contact

Analysis of the relationship between roughness parameters of wear surface and tribology performance of 5CB liquid crystal

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Rolling, sliding & torsion of micron-sized silica particles - Experimental, numerical and theoretical analysis