Abstract:The reactor coolant pump is a key equipment in a nuclear power plant. If the leakage exceeds a certain threshold, it may cause reactor overheating and shutdown. The reactor coolant pump leakage fault usually has two problems: corrosion and scaling. Accurately and efficiently diagnosing the leakage fault mode as early as possible and predicting its remaining useful life (RUL) are important for taking timely maintenance measures. In this paper, an integrated method is proposed. First, the cross-sectional area of the first seal is extracted as a fault indicator. The motivation is that corrosion may enlarge the cross-sectional area, and scaling may reduce the cross-sectional area. Based on the fluid mechanics theory, an integrated model with several uncertain parameters is established among the cross-sectional area, temperature, and leakage at the inlet and outlet of the first seal. In the diagnosing process, a modified change-detection method is proposed to detect the starting point of degradation. Then, the unknown parameters in the previous relation are estimated, and the degrading data before the starting point of degradation are used to diagnose the leakage fault mode. Second, a time-series model of the autoregressive integrated moving average (ARIMA) is established to predict the remaining useful life based on the degrading data after the starting point of degradation. Finally, the leakage degrading data from six reactor coolant pumps of a nuclear power plant is used to perform the leakage fault mode diagnosis and life prediction with degradation point detection error rates not exceeding 4%, fault mode diagnosis correction rates 100% and practical RUL predicting results, which proves that the proposed integrated method is accurate and efficient. The proposed integrated method combines the advantages of both the physical model diagnosis and the data-driven model diagnosis and innovatively make use of the quantity of flow from the output side of the primary pump as the monitoring indicator and the cross-sectional area as the characteristic index together to diagnose the leakage fault mode happened to the seal and predict its RUL, which can meet the needs of actual operation and maintenance to ensure a healthy and stable operation of the pump and prevent unexpected shutdowns of nuclear power plants and serious accidents.

Experimental study on pressure fluctuation in header of nuclear power plant SEC system after long-term pump shutdown

A Simulation Study of Hydraulic Vibration caused by Clearance Flow in a Pump Turbine

Numerical Study of the Internal Fluid Dynamics of Draft Tube in Seawater Pumped Storage Hydropower Plant

Research And Practice Of Overpressure Protection System For Epr Primary Hydrostatic Test

Analysis of load rejection transient process based on static efficiency factor for hydraulic unit security assessment

Water Hammer Characteristics and Component Fatigue Analysis of the Essential Service Water System in Nuclear Power Plants

Investigations on Pressure Fluctuations in the S-Shaped Region of a Pump–Turbine

Fluid-Structure Coupling Analysis of a Pump-turbine Unit During the Pump Shutdown Transient Process

Inception behavior of the cavitation in nuclear reactor cooling pump

PREVENTION OF HYDRODYNAMIC INSTABILITY CONDITIONS IN SAFETY SYSTEMS WITH PUMPS OF NUCLEAR POWER PLANTS

Safety Analysis on the Water Wall in the 350 MW Supercritical CFB Boiler under Sudden Electricity Failure

Simulated safety analysis of a total loss of feedwater accident in the steam generator of CPR1000 nuclear power plant

Analysis of abnormal operation of condenser water chamber evacuation system in nuclear power plants

Pressure fluctuation characteristics of a pump turbine in a draft tube: New insight into water column separation

Research on transient hydraulic characteristics of the whole process of reactor coolant pump under shaft stuck accident

Experiment investigation of a secondary PRHR cooling effect on an integral facility after a LOCA accident

An integrated method for the leakage fault mode diagnosis and life prediction of the reactor coolant pump

Investigation of System Responses of the Maanshan Nuclear Power Plant to the Loss of Residual Heat Removal During Midloop Operation Using a RELAP5/MOD3 Simulation

Transient Simulation for a Pumped Storage Power Plant Considering Pressure Pulsation Based on Field Test

Study on the Water Intake of Heat Trap Blocked by Marine Life in Nuclear Power Plant

Real-time simulations to enhance distributed on-line monitoring and fault detection in Pressurized Water Reactors