Abstract:Under some postulated accidental conditions, the secondary loop of the reactor needs to release its pressure for consequent system action. During the pressure relief transient, the residual fluid mixture of water and the steam will pass through the heat-exchange tubes of the steam generator and the live-steam pipeline, which decreases the steam generator pressure and the steam generator temperature due to taking the heat stored in the components away. The pressure and the temperature during the transient needs to be controlled to protect the steam generator from the potential damage. A 250 MWth high temperature gas cooled reactor is selected to evaluate this countermeasure effect during the pressure relief transient in this paper. A thermal-hydraulic system analysis code is used for modeling and simulating the pressure relief transient after the accident occurs. The temperature change of the fluid and the components in the steam generator are relative to the pressure relief transient, which is dominated by the design of pressure relief valve. Larger diameter of pressure relief valve will result in more intensive blown-down transient which causes faster pressure decrease and stronger heat transfer between the inside walls of the components in the secondary loop and the fluid. The designed pressure value where the pressure relief valve closes will affect the transient also. The designed pressure value dominates the time of the pressure relief transient which affects the amount of the fluid from the pressure relief valve. Different amount of the fluid will take away different quantity of heat from the components in the secondary loop of reactor. The pressure relief transients with a series of different diameter of pressure relief valve under some typical designed pressure value were simulated and compared. The results indicate that the pressure and the temperature of the steam generator during the pressure relief transient could be controlled effectively with reasonable design on the pressure relief system, which will provide protection and benefit for the steam generator after the postulated accident.

Research And Practice Of Overpressure Protection System For Epr Primary Hydrostatic Test

Coordination and Control Principle Between Grid-related Protection of Large-scale Nuclear Units and Security Automatic Devices of Power Grids

Study on Optimization of PID for Feed-water Control System of RB Test in PWR Nuclear Power Station

Generation III Pressurized Water Reactors and China’s Nuclear Power

Research on protection control strategy of pressurized water reactor nuclear power units for typical power system faults

Study on Containment Pressure Response with Passive Containment Cooling System Performance under Design Basis Accident

Research on load rejection protection of PWR power plants at different power levels

Experiment investigation of a secondary PRHR cooling effect on an integral facility after a LOCA accident

The prospect of the modeling simulation for the passive containment cooling system of the advanced PWR in China

Research on Compliance Between Large Break LOCA of HPR1000 and New LOCA Acceptance Criterion 10Cfr50.46c

Experimental Research On Steam Condensation On Cold Surface: Facility Design

Analysis of Load-Following Characteristics for an Integrated Pressurized Water Reactor

Risk-based method for substantiating reduction of pressure of hydraulic strength tests and its application on steam line of nuclear power plant with WWER (PWR) reactor plant

Design and Realization of Water Distribution Experiment System for High-power Pressurized Water Reactor PCS

Research on overspeed protection control strategies of PWR nuclear power units

Research and Evaluation for Passive Safety System in Low Pressure Reactor

Experimental study on pressure fluctuation in header of nuclear power plant SEC system after long-term pump shutdown

The primary loop confinement and pressure boundary system of the HTR-10

Analysis of Pressure Response in Modified VVP/ARE Compartments of Hongyanhe Nuclear Power Plant

Calculation Analysis on the Natural Circulation of a Passive Residual Heat Removal System for IPWR

Study on pressure relief system design for high temperature gas cooled reactor