Abstract:Granular flows with solid particles play an important role in energy and catalysis applications. To predict thermal performance, this study develops a comprehensive discrete particle tracking flow model fully coupled with conductive and radiative heat transfer. Leveraging LIGGGHTS, our model uniquely integrates particle-particle and particle-wall thermal radiation for grey radiative surfaces up to nearly 10 times of particle size. Models include: (a) plug flows of particles with a near-constant streamwise velocity and (b) gravity-driven, dense, moving beds of particles to determine wall-to-particle heat-transfer coefficients with isothermal channel walls. The plug flow model is used to interrogate the interdependent effects of flow-regime-dependent solid volume fractions (0.02 -- 0.48), particle size (0.4 -- 1 mm), operating wall temperatures (700 -- 1300 K), and thermophysical particles properties including emissivity (0.1 -- 1) and thermal conductivity (0.16, 33 W/m/K). The overall and conductive heat-transfer coefficients increase with solid volume fraction, while radiation contribution decreases. For a fixed solid volume fraction, heat-transfer coefficients exhibit linear dependence on particle emissivity and cubic dependence on wall temperature, driven by enhanced thermal radiation. For a fixed mass flow rate, the dependence of radiative heat-transfer coefficient on particle size changes with solid volume fraction. To generalize the applicability of our results, heat-transfer coefficients are transformed into a dimensionless Nusselt number, and establish its dependence on solid volume fraction. These results reveal the high sensitivity of the overall Nusselt number to even small changes in solid volume fraction in the dense flow regime, particularly for the high-conductivity alumina particles. In contrast, the radiative Nusselt number asymptotes for large solid volume fractions.

Development of Nusselt number and friction factor models for rough rod bundles based on wall functions

Frictional Resistance Investigation of Sco2 and a Semi-Empirical Friction Factor Correlation Based on Wall-of-the-law

Numerical Research on Convective Heat Transfer and Resistance Characteristics of Turbulent Duct Flow Containing Nanorod-Based Nanofluids

CFD evaluation of turbulence models for flow simulation of the fuel rod bundle with a spacer assembly

Convective Heat Transfer Coefficient for a Rod-Like Particle in a Uniform Flow

Study on the Prediction of DNB-Type Critical Heat Flux in Rod Bundle Under Motion Conditions

Experimental study on flow and heat transfer of medium-Prandtl-number fluid along a hexagonal helical cruciform seven-rods

Numerical investigation on mixing performance in rod bundle with spacer grid based on anisotropic turbulent mixing model

Friction factor and heat transfer prediction of rocket engine cooling channels in numerical simulations with high roughness Reynolds number

Numerically simulating the thermal–hydraulic characteristics within the fuel rod bundle using CFD methodology

Numerical investigation on critical heat flux for 5 × 5 fuel assemblies with a wide range of working conditions

Study on coupling effect of CRUD growth and heat transfer on fuel rod

Multidimensional modeling of fuel-cladding friction in an LWR fuel rod

Numerical study on surface corrosion deposition of fuel elements and its influence on flow heat transfer

New Friction Factor Equations Developed for Turbulent Flows in Rough Helical Tubes

Friction Factor and Nusselt Number Correlations for Forced Convection in Helical Tubes

Conductive and Radiative Heat Transfer Mechanisms Inform Nusselt Number Dependence on Solid Volume Fraction for Granular Flows

The reduced-order model of 5 × 5 fuel rod bundles

Transition of heat transfer mechanism of concurrent flame spread over discrete fuels

Periodicity and transversal pressure distribution in a Wire‐wrapped 19‐Pin fuel assembly

Development of a heat transfer model for the film boiling regime in a fouling layer