Abstract:When smelting silicon manganese alloy in an industrial electric furnace, it will produce smoke and dust waste gas, which can be utilized again back to the furnace and improve the utilization rate of raw materials after a particular trapping device and collection treatment. However, at higher moisture levels, they are prone to explode. Effects of various initial masses, initial moisture contents, and microwave output powers on the soot ash of smelting silicon manganese alloy were studies. The findings indicate that the microwave drying rate increases with all three variables. The time for complete microwave drying is directly proportional to the sample's initial moisture content and the sample's initial mass, and the time for complete microwave drying is inversely proportional to the microwave output power. The results demonstrate that the Modified Page model can accurately describe the microwave drying process. The experimental data were fitted experimentally by drying kinetic models. Microscopic characterization of soot ash from refining silico‑manganese alloys before and after drying was carried out using FTIR and SEM. Through FTIR characterization, the peak value of the -OH absorption peak decreases upon drying, and SEM results in no agglomeration caused by microwave drying and better dispersion of the soot ash of the dried smelted silica‑manganese alloys, all of which proved that microwaves could effectively remove water. It was discovered that the diffusion coefficient increased gradually with increasing power when it was computed using Fick's second law. The diffusion coefficient increases and then decreases as the moisture content increases. The diffusion coefficient decreases as the initial mass increases. Activation energy of microwave drying of soot ash from the refining of silicomanganese alloys was calculated to be -1.4467 W/g. Its purpose is to offer a detailed guide for the industrial drying of soot ash from silicomanganese alloy refinement using microwave drying technology.

Kinetics of microwave carbothermal reduction of Sb2O3: Isothermal and non‐isothermal microwave thermogravimetric analysis

Preparation of Antimony Metal by Carbothermal Reduction of Antimony Oxide Powder in a Microwave Field: Mechanism and Process

Reduction mechanism and optimization of prepare metallic antimony through direct microwave carbothermal reduction of antimony oxide concentrate

Basic study on microwave carbon-thermal reduction senarmontite (Sb2O3) to produce antimony: High-temperature dielectric properties and a microwave reduction mechanism

Metallic antimony preparation by carbothermic reduction of stibnite concentrates: strategies, mechanisms, and comparison of microwave and conventional roasting

Effects of Microwave Heating on the Carbothermic Reduction of Steel Plant Mill Scale Using Lignocellulosic Biomass As the Reducing Agent

Microwave-assisted synthesis of Sb2Se3 submicron rods, compared with those of Bi2Te3 and Sb2Te3.

Mechanism study on the high-phosphorus hematite carbothermal reduction in microwave field

Thermodynamics and kinetics of the carbothermal reduction of aluminum sulfate

Carbothermal Reduction Synthesis Of Zirconium Diboride Powders Assisted By Microwave

Experimental Investigation on the Mass Diffusion Behaviors of Calcium Oxide and Carbon in the Solid-State Synthesis of Calcium Carbide by Microwave Heating

Experiment study on the high-phosphorus hematite carbothermal reduction in microwave field

Kinetics of Microwave Radiation Pulverized Coal Combustion Based on Non-Isothermal Thermogravimetric Analysis

Study on Slag-Metal Separation Behavior of Chromite by Silicothermic Reduction

Promoting Effect of Microwave Field on Gas Phase Diffusion Limited Magnetite Reduction in Carbon Monoxide

Kinetics and Mechanism of Red Mud Carbothermic Reduction and Reduced Iron Grain Growth: An Influence of Sodium Sulfate

Rapid microwave-assisted reduction of ferromanganese spinel with biochar: Correlation between phase transformation and heating mechanism

Chemical Thermodynamics and Kinetics of Thiophenic Sulfur Removed from Coal by Microwave: A Density Functional Theory Study

Drying kinetics and energy efficiency of soot ash of smelting silicon manganese alloys under microwave heating

Selective recovery of antimony from Sb-bearing copper concentrates by integration of alkaline sulphide leaching solutions and microwave-assisted heating: A new sustainable processing route

Experimental Study on Smelting Reduction of Carbon-Bearing Manganese Briquettes in Slag Bath