Abstract:Determining the mechanical properties of frozen rock is highly important in cold-area engineering, but is laborious. These properties are essentially correlated with the content of liquid water remaining in frozen rock. Therefore, accurate determination of unfrozen water content could allow rapid evaluation of mechanical properties. This paper investigates the hysteresis characteristics of ultrasonic waves applied to sandstone (in terms of the parameters of P-wave velocity, amplitude, dominant frequency and quality factor Q) and their relationships with unfrozen water content during the freeze-thaw process. Their correlations are analysed in terms of their potential for use as indicators of freezing state and unfrozen water content. The results show that: (1) During a freeze-thaw cycle, the ultrasonic parameters and unfrozen water content of sandstone have significant hysteresis with changes in temperature. (2) There are three clear stages of change during freezing: supercooled stage (0 °C to −2 °C), rapid freezing stage (−2 °C to −3 °C), and stable freezing stage (−3 °C to −20 °C). The changes in unfrozen water content and ultrasonic parameters with freezing temperature are inverse. (3) During a single freeze-thaw cycle, the ultrasonic parameters of sandstone are significantly correlated with its unfrozen water content, and this correlation is affected by the pore structure. For sandstones with mesopores greater than 50%, there are inflection points in the curves of ultrasonic parameters vs. unfrozen water content at −3 °C during freezing and at –1 °C during thawing. It was found that thermal deformation of the mineral-grain skeleton and changes in the phase composition of pore water change the propagation path of ultrasonic waves. The inflection point in the curve of dominant frequency vs. temperature clearly marks the end of the rapid freezing stage of pore water, in which more than 70% of the pore water freezes. Consequently, the dominant frequency can be used as an index to conveniently estimate the frozen water content of frozen rock and, hence, its mechanical properties.

Frozen and unfrozen moisture content estimation in coral calcareous sand during artificial freezing

Effects of ice content on compression characteristics of frozen sandstone by in-situ NMR technology

Numerical simulation of the freezing process of concrete

Estimation of Ice Content in Mortar Based on Electrical Measurements under Freeze-Thaw Cycle

Establishment and analysis of the volumetric deformation model of sandstone pores under the effect of freezing-thawing cycles

Hysteresis in the ultrasonic parameters of saturated sandstone during freezing and thawing and correlations with unfrozen water content

An NMR-based Investigation of Pore Water Freezing Process in Sandstone

A model of unfrozen water content in rock during freezing and thawing with experimental validation by nuclear magnetic resonance

A mathematic model for the soil freezing characteristic curve: the roles of adsorption and capillarity

Modeling the Unfrozen Water Content of Frozen Soil Based on the Absorption Effects of Clay Surfaces

Theoretical Model for Estimation of Ice Content of Concrete by Using Electrical Measurements

Stress Analysis for Concrete Materials under Multiple Freeze-Thaw Cycles

Effect of fines content on soil freezing characteristic curve of sandy soils

Study on the evolution of the dielectric properties of artificially frozen sand under temperature variation

Numerical analysis study on determination of unfrozen water saturation curve for sandy soil

Molecular Insights into the Freezing Process of Water on the Basal Surface of Muscovite Mica

Evolution of the Unfrozen Water Content for Partially-Saturated Sandstones and the Critical Degree of Saturation

Premelting Theory‐Based Mechanism for Water Freezing in Saline Soil

Effects of cyclic freezing and thawing on the mechanical behavior of dried and saturated sandstone

Pore‐scale freezing of a sandy saline soil visualized with micro‐computed tomography

Investigating Icing Behavior in Cementitious Material During Freeze–thaw Using Low-Temperature Low-Field NMR