Abstract:In order to investigate the impact of freeze–thaw damage on sandstone under the coupling of ground stress and pore water pressure, three types of porous sandstone were subjected to freezing at different negative temperatures (−5 °C, −10 °C, −15 °C, and −20 °C). Subsequently, hydraulic coupling triaxial compression tests were conducted on the frozen and thawed sandstone. We analyzed the effects of porosity and freezing temperature on the mechanical properties of sandstone under hydraulic coupling and performed nuclear magnetic resonance tests on sandstone samples before and after freezing and thawing. The evolution of the pore structure in sandstone at various freezing and thawing stages was studied, and a statistical damage constitutive model was established to validate the test results. The results indicate that the stress–strain curves of sandstone samples under triaxial compression after a freeze–thaw cycle exhibit minimal changes compared to those without freezing at normal temperature. The peak deviator stress shows a decreasing trend with decreasing freezing temperature, particularly between −5 °C and −10 °C, and then gradually stabilizes. The elastic modulus of sandstone with different porosity decreases with the decrease in freezing temperature, and the decrease is more obvious in the range of −5 °C~−10 °C, decreasing by 2.33%, 6.11%, and 10.5%, respectively. Below −10 °C, the elastic modulus becomes similar to that at −10 °C, and the change tends to stabilize. The nuclear magnetic porosity of sandstone samples significantly increases after freezing and thawing. The smaller the initial porosity, the greater the rate of change in nuclear magnetic porosity after a freeze–thaw cycle. The effects of freeze–thaw damage on the T2 distribution of sandstone with different porosity levels vary. We established a statistical damage constitutive model considering the combined effects of freeze–thaw damage, ground stress, and pore water pressure. The compaction coefficient K was introduced into the constitutive model for optimization. The change trend of the theoretical curve closely aligns with that of the test curve, better characterizing the stress–strain relationship of sandstone under complex pressure environments. The research findings can provide a scientific basis for wellbore wall design and subsequent maintenance in complex environments.

Establishment and analysis of the volumetric deformation model of sandstone pores under the effect of freezing-thawing cycles

Mechanical Properties and Damage Constitutive Model of Saturated Sandstone Under Freeze–Thaw Action

Study on the pore structure characteristics and damage constitutive model of sandstone under freeze-thaw conditions

Damage characteristics of sandstone pore structure under freeze-thaw cycles

Dynamic tensile mechanical properties of water-saturated and frozen sandstone after freeze-thaw fatigue damage treatment

NMR Pore Structure and Dynamic Characteristics of Sandstone Caused by Ambient Freeze-Thaw Action

Evolution in sandstone pore structures with freeze-thaw cycling and interpretation of damage mechanisms in saturated porous rocks

Effect of freeze–thaw cycle on physical and mechanical properties and damage characteristics of sandstone

Study on the Influence of Saturation on Freeze–Thaw Damage Characteristics of Sandstone

Impact of Water Saturation on the Damage Evolution Characteristics of Sandstone Subjected to Freeze–Thaw Cycles

Effects of cyclic freezing and thawing on the mechanical behavior of dried and saturated sandstone

Nuclear magnetic resonance analysis of the failure and damage model of rock masses during freeze‒thaw cycles

Experimental and Theoretical Study on Frost Deformation and Damage of Red Sandstones with Different Water Contents

Stress Analysis for Concrete Materials under Multiple Freeze-Thaw Cycles

Pore structure expansion and evolution in sandstone with prefabricated crack under freeze-thaw cycles based on CT scanning

Heterogeneous Frost Deformation of Partially Saturated Sandstones Due to the Freeze–Thaw Cycle

Experimental Investigation On The Effects Of Ambient Freeze-Thaw Cycling On Creep Mechanical Properties Of Sandstone Under Step Loading

Frost Damage in Tight Sandstone: Experimental Evaluation and Interpretation of Damage Mechanisms

Decay function and damage strain model of fresh sandstone subjected to freeze–thaw cycles

Macro-mesoscopic Correlation Investigation on Damage Evolution of Sandstone Subjected to Freeze–Thaw Cycles

Study on the microscopic damage evolution and dynamic fracture properties of sandstone under freeze-thaw cycles