Abstract:In order to investigate the impact of freeze–thaw damage on sandstone under the coupling of ground stress and pore water pressure, three types of porous sandstone were subjected to freezing at different negative temperatures (−5 °C, −10 °C, −15 °C, and −20 °C). Subsequently, hydraulic coupling triaxial compression tests were conducted on the frozen and thawed sandstone. We analyzed the effects of porosity and freezing temperature on the mechanical properties of sandstone under hydraulic coupling and performed nuclear magnetic resonance tests on sandstone samples before and after freezing and thawing. The evolution of the pore structure in sandstone at various freezing and thawing stages was studied, and a statistical damage constitutive model was established to validate the test results. The results indicate that the stress–strain curves of sandstone samples under triaxial compression after a freeze–thaw cycle exhibit minimal changes compared to those without freezing at normal temperature. The peak deviator stress shows a decreasing trend with decreasing freezing temperature, particularly between −5 °C and −10 °C, and then gradually stabilizes. The elastic modulus of sandstone with different porosity decreases with the decrease in freezing temperature, and the decrease is more obvious in the range of −5 °C~−10 °C, decreasing by 2.33%, 6.11%, and 10.5%, respectively. Below −10 °C, the elastic modulus becomes similar to that at −10 °C, and the change tends to stabilize. The nuclear magnetic porosity of sandstone samples significantly increases after freezing and thawing. The smaller the initial porosity, the greater the rate of change in nuclear magnetic porosity after a freeze–thaw cycle. The effects of freeze–thaw damage on the T2 distribution of sandstone with different porosity levels vary. We established a statistical damage constitutive model considering the combined effects of freeze–thaw damage, ground stress, and pore water pressure. The compaction coefficient K was introduced into the constitutive model for optimization. The change trend of the theoretical curve closely aligns with that of the test curve, better characterizing the stress–strain relationship of sandstone under complex pressure environments. The research findings can provide a scientific basis for wellbore wall design and subsequent maintenance in complex environments.

Macro-mesoscopic Correlation Investigation on Damage Evolution of Sandstone Subjected to Freeze–Thaw Cycles

Energy evolution and macro-micro failure mechanisms of frozen weakly cemented sandstone under uniaxial cyclic loading and unloading

Study on the microscopic damage evolution and dynamic fracture properties of sandstone under freeze-thaw cycles

Study on the pore structure characteristics and damage constitutive model of sandstone under freeze-thaw conditions

Effect of freeze–thaw cycle on physical and mechanical properties and damage characteristics of sandstone

Damage mechanism of sandstones subject to cyclic freeze–thaw (FT) actions based on high-resolution computed tomography (CT)

Decay function and damage strain model of fresh sandstone subjected to freeze–thaw cycles

Quantitative Study of the Failure Characteristics of Sandstone with Freeze–Thaw Damage: Insight into the Cracking Behavior

Influence of Microstructure on Dynamic Mechanical Behavior and Damage Evolution of Frozen-Thawed Sandstone Using Computed Tomography

Damage characteristics of sandstone pore structure under freeze-thaw cycles

Degradation of Physico-Mechanical Properties and Damage Mechanisms of Sandstone under the Combined Action of Freeze–thaw Cycles, Chemical Solution, and Compressive Stress

Pore structure expansion and evolution in sandstone with prefabricated crack under freeze-thaw cycles based on CT scanning

Study on the Influence of Saturation on Freeze–Thaw Damage Characteristics of Sandstone

Study on the mechanical properties of saturated red sandstone under freeze–thaw conditions

Macroscopic and microscopic mechanical characteristics and crack propagation behavior of sandstone-like samples with single cracks under freeze-thaw cycles: Experimental and numerical simulation

Mechanical Properties and Damage Constitutive Model of Saturated Sandstone Under Freeze–Thaw Action

Mechanical Characteristics of Red Sandstone Subjected to Freeze–Thaw Cycles and Increasing Amplitude Cyclic Load

Impact of Water Saturation on the Damage Evolution Characteristics of Sandstone Subjected to Freeze–Thaw Cycles

Strength degradation characteristics and damage constitutive model of sandstone under freeze–thaw cycles

Research on Deterioration Mechanism and Dynamic Triaxial Compression Characteristics of Freeze–Thaw Sandstone

Nuclear magnetic resonance analysis of the failure and damage model of rock masses during freeze‒thaw cycles