Abstract:In order to investigate the impact of freeze–thaw damage on sandstone under the coupling of ground stress and pore water pressure, three types of porous sandstone were subjected to freezing at different negative temperatures (−5 °C, −10 °C, −15 °C, and −20 °C). Subsequently, hydraulic coupling triaxial compression tests were conducted on the frozen and thawed sandstone. We analyzed the effects of porosity and freezing temperature on the mechanical properties of sandstone under hydraulic coupling and performed nuclear magnetic resonance tests on sandstone samples before and after freezing and thawing. The evolution of the pore structure in sandstone at various freezing and thawing stages was studied, and a statistical damage constitutive model was established to validate the test results. The results indicate that the stress–strain curves of sandstone samples under triaxial compression after a freeze–thaw cycle exhibit minimal changes compared to those without freezing at normal temperature. The peak deviator stress shows a decreasing trend with decreasing freezing temperature, particularly between −5 °C and −10 °C, and then gradually stabilizes. The elastic modulus of sandstone with different porosity decreases with the decrease in freezing temperature, and the decrease is more obvious in the range of −5 °C~−10 °C, decreasing by 2.33%, 6.11%, and 10.5%, respectively. Below −10 °C, the elastic modulus becomes similar to that at −10 °C, and the change tends to stabilize. The nuclear magnetic porosity of sandstone samples significantly increases after freezing and thawing. The smaller the initial porosity, the greater the rate of change in nuclear magnetic porosity after a freeze–thaw cycle. The effects of freeze–thaw damage on the T2 distribution of sandstone with different porosity levels vary. We established a statistical damage constitutive model considering the combined effects of freeze–thaw damage, ground stress, and pore water pressure. The compaction coefficient K was introduced into the constitutive model for optimization. The change trend of the theoretical curve closely aligns with that of the test curve, better characterizing the stress–strain relationship of sandstone under complex pressure environments. The research findings can provide a scientific basis for wellbore wall design and subsequent maintenance in complex environments.

Evolution of the Unfrozen Water Content for Partially-Saturated Sandstones and the Critical Degree of Saturation

Impact of Water Saturation on the Damage Evolution Characteristics of Sandstone Subjected to Freeze–Thaw Cycles

Heterogeneous Frost Deformation of Partially Saturated Sandstones Due to the Freeze–Thaw Cycle

Experimental and Theoretical Study on Frost Deformation and Damage of Red Sandstones with Different Water Contents

Effects of ice content on compression characteristics of frozen sandstone by in-situ NMR technology

Study on the Influence of Saturation on Freeze–Thaw Damage Characteristics of Sandstone

Hysteresis in the ultrasonic parameters of saturated sandstone during freezing and thawing and correlations with unfrozen water content

Linking the mechanical properties of frozen sandstone to phase composition of pore water measured by LF-NMR at subzero temperatures

Mechanical Properties and Damage Constitutive Model of Saturated Sandstone Under Freeze–Thaw Action

Effect of water saturation on uniaxial compressive strength and damage degree of clay-bearing sandstone under freeze-thaw

A model of unfrozen water content in rock during freezing and thawing with experimental validation by nuclear magnetic resonance

An experimental study on the influence of ice saturation and sub-zero temperatures on the dynamic mechanical properties of sandstones

Evolution characteristics of freeze–thaw-induced sandstone damage under water immersion conditions in Changdu, Tibet, China

Evolution in sandstone pore structures with freeze-thaw cycling and interpretation of damage mechanisms in saturated porous rocks

Damage characteristics of sandstone pore structure under freeze-thaw cycles

Frost Damage in Tight Sandstone: Experimental Evaluation and Interpretation of Damage Mechanisms

Dynamic tensile mechanical properties of water-saturated and frozen sandstone after freeze-thaw fatigue damage treatment

Coupled effects of chemical environments and freeze–thaw cycles on damage characteristics of red sandstone

Phase Transition in Geomaterials Under Unsaturated Conditions

Stress Analysis for Concrete Materials under Multiple Freeze-Thaw Cycles

The influence of saturation and loading angle on sandstone damage characteristics after freeze-thaw cycle