Abstract:This study integrates the hardware circuit design and the development support of the software interface to achieve a 32-channel EEG system for BCI applications. Since the EEG signals of human bodies are generally very weak, in addition to preventing noise interference, it also requires avoiding the waveform distortion as well as waveform offset and so on; therefore, the design of a preamplifier with high common-mode rejection ratio and high signal-to-noise ratio is very important. Moreover, the friction between the electrode pads and the skin as well as the design of dual power supply will generate DC bias which affects the measurement signals. For this reason, this study specially designs an improved single-power AC-coupled circuit, which effectively reduces the DC bias and improves the error caused by the effects of part errors. At the same time, the digital way is applied to design the adjustable amplification and filter function, which can design for different EEG frequency bands. For the analog circuit, a frequency band will be taken out through the filtering circuit and then the digital filtering design will be used to adjust the extracted frequency band for the target frequency band, combining with MATLAB to design man-machine interface for displaying brain wave. Finally the measured signals are compared to the traditional 32-channel EEG signals. In addition to meeting the IFCN standards, the system design also conducted measurement verification in the standard EEG isolation room in order to demonstrate the accuracy and reliability of this system design.

Design of Analog Front-End for 128 Multi-Channel EEG Signal Acquisition in 90 nm Technology

EEG Acquisition System Based on Analog Front-End ADS1299

Low-noise High Input Impedance 8-Channels Chopper-Stabilized EEG Acquisition System

Design of a self-organized Intelligent Electrode for synchronous measurement of multiple bio-signals in a wearable healthcare monitoring system

A Design of EES Analog Pre-processing Circuit

An 8-Channel Biomedical Front-End (BFE) with 6.2-Μw Per Channel for EEG/ECoG Acquisition

A 0.5-V multi-channel low-noise readout front-end for portable EEG acquisition

A Two-Stage Time-Division Multiplexing AFE with Input Impedance Boosting DDA for EEG Signal Acquisition

An 8-Channel Wearable EEG Acquisition Front-End IC with Integrated Multi-Functions

A 108 dB DR Δ∑-∑M Front-End With 720 mVpp Input Range and >±300 mV Offset Removal for Multi-Parameter Biopotential Recording.

Design of an Attention Evaluation System with 16-Channel Differential Signal Acquisition

A 66-Db Sndr, 8-Mu W Analog Front-End For Ecg/Eeg Recording Application

A Digitally Trimmable Low-Noise Low-Power Analog Front-End for EEG Signal Acquisition

Design of a 32-channel EEG system for brain control interface applications

Design and Analysis of a High-Gain, Low-Noise, and Low-Power Analog Front End for Electrocardiogram Acquisition in 45 nm Technology Using gm/ID Method

A 20 Μw Dual-Channel Analog Front-End in 65nm CMOS for Portable ECG Monitoring System

A TDM-based Analog Front-End for Ear-EEG Recording with 74.5-GΩ Input Impedance, 384-mV DC Tolerance and 0.27-μVrms Input-Referred Noise

A Current-Reuse DDA-Based Analog Front End for Multi-Biological Signal Acquisition

A low power analog front-end for portable biopotential acquisition systems

A 11G-Input-Impedance 700mV<sub>pp</sub>-Input-Signal-Range 87dB-SNDR Direct-Digitization AFE for Wearable EEG Recording

From spikes to EEG: integrated multichannel and selective acquisition of neuropotentials