Abstract:Advances in brain-machine interfaces and wearable biomedical sensors for healthcare and human-computer interactions call for precision electrophysiology to resolve a variety of biopotential signals across the body that cover a wide range of frequencies, from the mHz-range electrogastrogram (EGG) to the kHz-range electroneurogram (ENG). Existing integrated wearable solutions for minimally invasive biopotential recordings are limited in detection range and accuracy due to trade-offs in bandwidth, noise, input impedance, and power consumption. This article presents a 16-channel wide-band ultra-low-noise neural recording system-on-chip (SoC) fabricated in 65nm CMOS for chronic use in mobile healthcare settings that spans a bandwidth of 0.001 Hz to 1 kHz through a featured sample-level duty-cycling (SLDC) mode. Each recording channel is implemented by a delta-sigma analog-to-digital converter (ADC) achieving 1.0 μ V <sub>rms</sub> input-referred noise over 1Hz-1kHz bandwidth with a Noise Efficiency Factor (NEF) of 2.93 in continuous operation mode. In SLDC mode, the power supply is duty-cycled while maintaining consistently low input-referred noise levels at ultra-low frequencies (1.1 μV <sub>rms</sub> over 0.001Hz-1Hz) and 435 M Ω input impedance. The functionalities of the proposed SoC are validated with two human electrophysiology applications: recording low-amplitude electroencephalogram (EEG) through electrodes fixated on the forehead to monitor brain waves, and ultra-slow-wave electrogastrogram (EGG) through electrodes fixated on the abdomen to monitor digestion.

An 8-Channel Wearable EEG Acquisition Front-End IC with Integrated Multi-Functions

A Front-End Circuit With 16-Channel 12-Bit 100-Ksps Rc-Hybrid Sar Adc For Industrial Monitoring Application

Design of a self-organized Intelligent Electrode for synchronous measurement of multiple bio-signals in a wearable healthcare monitoring system

An ASIC Solution for Intelligent Electrodes and Active-Cable Used in a Wearable ECG Monitoring System.

A Multi-Parameter Bio-Electric ASIC Sensor with Integrated 2-Wire Data Transmission Protocol for Wearable Healthcare System

A 108db DR Hybrid-CTDT Direct-Digitalization ΔΣ-ΣM Front-End with 720mvpp Input Range and >300mv Offset Removal for Wearable Bio-Signal Recording.

A 0.5-V multi-channel low-noise readout front-end for portable EEG acquisition

An 8-Channel Biomedical Front-End (BFE) with 6.2-Μw Per Channel for EEG/ECoG Acquisition

A 49nV/√Hz 87.8dB-SNDR 4-Channel Digital Active Electrode System for Gel-Free and Motion-Tolerant Wearable EEG Acquisition.

A Wireless 8-Channel ECG Biopotential Acquisition System for Dry Electrodes

Low-noise High Input Impedance 8-Channels Chopper-Stabilized EEG Acquisition System

A 11GΩ-Input-Impedance 700mV<inf>pp</inf>-Input-Signal- Range 87dB-SNDR Direct-Digitization AFE for Wearable EEG Recording

An ECG-on-Chip for Wearable Cardiac Monitoring Devices

A 1.5 mm2 4-Channel EEG/BIOZ Acquisition ASIC With 15.2-Bit 3-Step ADC Based on a Signal-Dependent Low-Power Strategy

An 800MΩ-Input-Impedance 95.3dB-DR Δ-ΔΣ AFE for Dry-Electrode Wearable EEG Recording

A Low-Noise Low-Power 0.001Hz–1kHz Neural Recording System-on-Chip with Sample-Level Duty-Cycling

A $64.8~\mu$ W > 2.2 G $\omega$ DC–AC Configurable CMOS Front-End IC for Wearable ECG Monitoring

A 11G-Input-Impedance 700mV<sub>pp</sub>-Input-Signal-Range 87dB-SNDR Direct-Digitization AFE for Wearable EEG Recording

A 107.6 dB-DR Three-Step Incremental ADC for Motion-Tolerate Biopotential Signals Recording

An Area Efficient Low Power ECoG Front-End Chip for Digitalized Subdural Grid

A 66-Db Sndr, 8-Mu W Analog Front-End For Ecg/Eeg Recording Application