Abstract:This article presents the comparison between the unsteady flow characteristics of thick (t/c ≥ 6%) and thin (t/c ≤ 6%) airfoils performing pitching motion at Reynolds number Re=3.6×105. For the analysis, the considered airfoils are NACA 0012 as thick and symmetric airfoil and GOE 417A as thin and highly cambered airfoil. The analysis in this study is restricted to only two airfoils because from the preliminary investigations, similar aerodynamic characteristics with slight variation in their flow field development under same conditions were observed. The influence of reduced frequency, pitching amplitude and mean angle of attack on the airfoil's aerodynamic performance in terms of instantaneous force coefficients is thoroughly investigated. Further, the flow surrounding the airfoils is also investigated. It is noticed that the aforementioned parameters substantially affect the instantaneous force coefficients (both qualitatively and quantitatively). Under certain conditions, the formation of reverse Karman vortex street was observed indicating airfoil's thrust force generation. It must be noted that the conditions where the thrust force generation occurs for thick and symmetric airfoils like NACA 0012 are quite different from that of thin and cambered airfoils like GOE 417A. Additionally, a drastic change in the flow field around the airfoils is observed under similar conditions. For NACA 0012 airfoil, the formation and convection of the Leading Edge Vortex (LEV) under certain conditions has detrimental effects on its aerodynamic characteristics as it encourages early flow separation. However, the same cannot be true for thin and highly cambered airfoils like GOE 417A. Under the similar conditions with negligible variation, the LEV contributes toward providing extra suction over the GOE 417A airfoil's suction side. This significantly improves airfoil's aerodynamic characteristics.

Ordinates and Theoretical Pressure-distribution Data for NACA 6- and 6a-series Airfoil Sections with Thicknesses from 2 to 21 and from 2 to 15 Percent Chord, Respectively

Effect of thickness, camber, and thickness distribution on airfoil characteristics at Mach numbers up to 1.0

An investigation on the effect of second-order additional thickness distributions to the upper surface of an NACA 64 sub 1-212 airfoil

Theoretical effect of modifications to the upper surface of two NACA airfoils using smooth polynomial additional thickness distributions which emphasize leading edge profile and which vary linearly at the trailing edge

Low-speed characteristics of four cambered, 10-percent-thick NACA airfoil sections

Influence of Relative Thickness on Static and Dynamic Stall Characteristics and Prediction of Airfoils

Airfoil Design Framework for Optimized Boundary-Layer Integral Parameters

Optimizing NACA Airfoil Thickness Function Parameters for Maximum Lift-to-Drag Ratio

Research on the pressure distribution under different airfoil types of aircraft

Maximum Thickness Location Selection of High Subsonic Axial Compressor Airfoils and Its Effect on Aerodynamic Performance

Airfoil Lift Calculation Using Wind Tunnel Wall Pressures

Numerical and Experimental Investigation of a NACA 64A-110 Airfoil in Transonic Flow Regime

Lift and drag coefficients of flow around a flat plate at high attack angles

Effects of Trailing Edge Thickness on NACA 4412 Airfoil Performance at Low Reynolds Numbers: A CFD Analysis

A New Systematic Series of Foil Sections with Parallel Sides

Comparative Assessment on Unsteady Aerodynamics of Thin and Thick Airfoils Subjected to Pitching Motion

Low-order planar pressure reconstruction of stalled airfoils using particle image velocimetry data

Adaptive sampling of pressure distribution features for the airfoil statistical analysis

Wind turbine airfoil family design method based on prescribed pressure gradient distributions

Effect of Ground Proximity on Aerodynamic Characteristics of NACA 4412 Airfoil.

Nonlinear geometric decomposition of airfoils into the thickness and camber contributions