Abstract:In this study, poly(vinylidene fluoride-co-hexafluoropropene) (P(VDF-co-HFP)) was firstly used as a membrane material in organophilic pervporation for aroma compounds’ recovery. Separation and transport properties of P(VDF-co-HFP) coated polypropene (PP) composite membrane in pervaporation of EtAc–water mixture were investigated. The effects of two process conditions (EtAc feed concentration and operating temperature) on pervaporation parameters (permeation flux and separation factor) were discussed in detail. The study shows that acetone-fabricated membranes have excellent mechanical strength, thermal stability and film-forming properties. In addition, they have ideal pervaporation performances compared to commonly used poly(dimethylsixolane) (PDMS) membrane and poly (ether block amide) (PEBA) membrane. Its separation factor is higher than that of PEBA membrane but lower that of PDMS membrane. The permeate flux is relatively high, which depends on not only the nature of the given membrane material but also the membrane-formed special structure and morphology. Mass transports in the membrane were investigated based on the change of microstructure from DSC analysis during the swelling process. The activation energies for permeation of water (EP,W) and EtAc (EP,E) calculated from the slopes of Arrhenius plots of ln(J) versus 1/T were employed to explain the diffusion process. In general, the sorption process dominates the separation mechanism.

Separation of methanol–benzene and methanol–toluene mixtures by pervaporation: effects of thermodynamics and structural phenomenon

A study on separation of organics by pervaporation

Study on Pervaporation Membranes for Removing Methanol from C 5 or Methyl Tert-butyl Ether Mixtures

Pervaporation of methanol/MTBE/C5 ternary mixtures through the CA membrane

Study on Swelling Behavior and Pervaporation Properties of AA–MMA–BA Copolymers for Separation of Methanol/mtbe/c5 Mixtures

Effect of the Permeants/Polymer Interactions on the Pervaporative Separation Properties of the P(Vdf-Co-Hfp) Membrane

Methanol-selective membranes for the pervaporative separation of methanol–toluene mixtures

P(Vdf-Co-Hfp) Membrane for Recovery of Aroma Compounds from Aqueous Solutions by Pervaporation - I. Ethyl Acetate/Water System

Pervaporation Separation of Ethanol from Aqueous Solution by PDMS Membranes Crosslinked with VTES

A Triacetate Cellulose Membrane for the Separation of Methyl Tert-Butyl Ether/Methanol Mixtures by Pervaporation

Crosslinked poly(vinyl alcohol) membranes for separation of dimethyl carbonate/methanol mixtures by pervaporation

Pervaporation for Separating Benzene/cyclohexane Mixture by P(AA-MA) Copolymer Membranes

Separation of Dimethyl Carbonate/Methanol Mixtures by Pervaporation with Poly(Acrylic Acid)/Poly(Vinyl Alcohol) Blend Membranes

Preparation and Pervaporation Performance of Partly Hydrolyzed Poly(vinyl Acetate) Membranes for Separating Benzene/Cyclohexane Mixtures

Separation of Ethanol from Ethanol/Water Mixtures by Pervaporation with Silicone Rubber Membranes: Effect of Silicone Rubbers

Vtos Cross-Linked Pdms Membranes for Recovery of Ethanol from Aqueous Solution by Pervaporation

Separation of azeotropic dimethylcarbonate/methanol mixtures by pervaporation: Sorption and diffusion behaviors in the pure and nano silica filled pdms membranes

Pervaporation Performances of Polydimethylsiloxane Membranes for Separating Dimethyl Carbonate/methanol Mixtures

Pervaporation of dimethyl carbonate/methanol mixtures through polydimethylsiloxane membranes

Pervaporation Performance Ofpoly(acrylic Acid)-Poly(vinyl Alcohol) Blend Membrane for Separation of Methanol-Dimethyl Carbonate Azeotrope

Effect of Pervaporation Module Structure on Separation Performance