Abstract:Thin film silicon solar cells are believed to be promising candidates for continuing cost reduction in photovoltaic panels because silicon usage could be greatly reduced. Since silicon is an indirect bandgap semiconductor, its absorption coefficient is low for photons in the wavelength ranges between 600nm and 1100nm. For high efficiency thin film modules, effective light trapping is essential. Traditional schemes such as textured transparent conductive oxide (TCO) and metal reflector have several disadvantages such as enhanced surface recombination, parasitic losses at the TCO/metal interface, and the lack of ability to control and optimize the textured surface. We have previously proposed to employ a light trapping structure, which combines a self-assembled submicron grating and a distributed Bragg reflector (DBR) on the backside of thin film silicon solar cells. The DBR works as a one-dimensional photonic crystal to obtain almost 100% reflectivity. The grating scatters the incident light into oblique angles to significantly enhance the optical path length. Numerical calculations predict that by optimizing the feature sizes of the grating and DBR, up to 31% relative efficiency increase can be obtained, compared to the bare thin film Si. By using self-assembly, the organized grating structure can be formed spontaneously at a much lower cost. Current-voltage relations and quantum efficiency measurements were taken to verify the performance of our designed back structure. In the wavelength range of 600-900nm, photon absorption is greatly enhanced. As a result, more than 20% relative efficiency enhancement is achieved for 1.5um thin film silicon cells. These numerical and experimental results show that a light trapping design can be low-cost and increase efficiencies for high performance thin film Si solar cells.

Non-uniform Al 2 O 3 back reflector for performance enhancement of thin rear passivated silicon solar cells

Novel back-reflector architecture with nanoparticle based buried light-scattering microstructures for improved solar cell performance

Broadband absorption enhancement in ultra‐thin crystalline Si solar cells by incorporating metallic and dielectric nanostructures in the back reflector

Integration of Self-Assembled Porous Alumina and Distributed Bragg Reflector for Light Trapping in Si Photovoltaic Devices

Enhanced performance of thin-film amorphous silicon (a-Si) solar cells encapsulated with distributed Bragg reflector pairs

Broadband Antireflection and Absorption Enhancement of Ultrathin Silicon Solar Microcells Enabled with Density-Graded Surface Nanostructures

Double layer antireflection coating for high-efficiency passivated emitter silicon solar cells

Enhancing Silicon Solar Cell Performance Using a Thin-Film-like Aluminum Nanoparticle Surface Layer

Combined Optical and Electrical Design of Plasmonic Back Reflector for High-Efficiency Thin-Film Silicon Solar Cells

Efficient Light Trapping Structure in Thin Film Silicon Solar Cells

Enhanced Efficiency in Thin Film Solar Cells: Optimized Design With Front Nanotextured and Rear Nanowire-Based Light Trapping Structure

Light-trapping Structures Based on Low-Melting Point Metals for Thin-Film Solar Cells

Small Pyramidal Textured Ultrathin Crystalline Silicon Solar Cells with Double-Layer Passivation.

Tuning Back Side Passivation for Enhancing the Performance of PERC Solar Cells

Nano-Photonic Structures for Light Trapping in Ultra-Thin Crystalline Silicon Solar Cells

How backreflection contributes to light absorption for high-performance radial junction photovoltaics

Enhanced Photovoltaic Performance of Inverted Pyramid-Based Nanostructured Black-Silicon Solar Cells Passivated by an Atomic-Layer-Deposited Al2o3 Layer

Optoelectronic optimization of graded-bandgap thin-film AlGaAs solar cells. Part II: optimal antireflection front-surface texturing

Omnidirectional Light Absorption in Thin Film Silicon Solar Cell with Dual Anti-Reflection Coatings

ALD Al2O3 based nanolaminates for solar cell applications