Abstract:Low-temperature water electrolysis can rapidly produce environmentally sustainable or green hydrogen, and is a prospective means of storing energy from renewable but intermittent power sources, such as wind and solar, in future clean energy infrastructure (1-4). Commercial water electrolysis either use liquid alkaline electrolyte or proton exchange membrane electrolyte (1). The proton exchange membrane water electrolysis (PEMWE) offers more advantages than the alkaline counterpart, such as higher purity of H 2 , lower resistance losses, more compact design, and what the most important is the compatible with the intermittent of the renewable energy (1-2). The grant challenge remaining in PEMWE is the development of the highly active, cost effective and stable catalysts for oxygen evolution reaction (OER), which is very sluggish requiring large amounts of precious metal as the catalysts, such as Ir, Ru and their oxides (1). In PEM water electrolysis cells, the catalysts should have high surface areas and high porosities that exposit sufficient active sites available to the reactants and electrolyte, as well as transferring the bubble out of the catalyst surface to ensure a fast mass transfer (5). Also, the OER is dependent on the inherent conductivity of the catalysts or the supports (1). For example, poor electronic conductivity within the catalyst layer will result in poor lateral conductivity across the catalyst layer, thus catalyst not in the vicinity of the porous transport layer will not participate in the reaction. To enable the widespread penetration of the PEMWE technologies, it is urgently to reduce the Ir loading to the sustainable level (~ 0.3 mg/cm 2 ) compared with the current commercial usage (2-6 mg/cm 2 ). Alternatively, to develop precious metal free catalyst with high efficiency and sustained durability (5). In this presentation, we will describe a method of preparing highly active yet stable synergistic electrocatalysts for oxygen evolution reaction for PEMWE. The new catalysts contain IrCoOx/ RuCoOx cluster and La&Li co-doped Co 3 O 4 fiber which was derived from cobalt zeolitic imidazolate framework as precursor. The OER activities of the catalysts were first tested in O 2 saturated acidic electrolyte by ring disk electrode (RDE), which displayed high mass activity 26-50 times that of commercial Ir and RuO 2 . The catalysts were fabricated into membrane electrode assemble and measured under real PEM water electrolysis condition. The cells demonstrated 2 A/cm 2 @1.76 V @0.25 ± 0.05 mg Ir /cm 2 loading, and negligible degradation after ~250 h chronoamperometric measurements at 2 A/cm 2 (6), which meets the target set by US DOE for OER catalysts for PEMWE. The characterizations of the fresh and post-electrochemical samples were investigated by X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), X-ray absorption near-edge structure (XANES), extended X-ray absorption fine structure (EXAFS), transmission electron microscopy (TEM), Raman spectroscopy and BET surface analysis. We also performed DFT simulation on the OER reaction pathways over Ir and Co sites of different facets parallelly on basis of the TEM results. The result reveals the synergy between Ir/Ru and Co resulting in the enhanced catalytic activities of both IrCoOx /RuCoOx and LaLi@Co 3 O 4 toward OER. Acknowledgments: This work was supported by Overseas Outstanding Youth Fund project, shanghai Jiao Tong university, Shanghai, China; Shanghai Pujiang talent Plan, Shanghai, China; Argonne National Laboratory through Maria Goeppert Mayer Fellowship, US; State Key Laboratory of Metal Matrix Composites, shanghai Jiao Tong university, Shanghai, China. The works performed at Hydrogen research center, shanghai Jiao Tong university, and Argonne National Laboratory’s Center for Nanoscale Materials and Advanced Photo Source. Reference: K. Ayers et al., Annu. Rev. Chem. Biomol. Eng. 10, 219–239 (2019). M. Carmo, D. L. Fritz, J. Mergel, D. Stolten, Int. J. Hydrogen Energy 38, 4901–4934 (2013). M. T. M. Koper, J. Electroanal. Chem. 660, 254–260 (2011). R. D. L. Smith et al., Science 340, 60–63 (2013). Chong et al., Science 380, 609–616 (2023). Chong et al., Adv. Energy Mater. 2023, 2302306.

Agglomerate Engineering to Boost PEM Water Electrolyzer Performance (Adv. Energy Mater. 41/2024)

Manipulating the Electrochemical Surface Reconstruction of Nickel Foam Via Electrolyte Engineering for Efficient Oxygen Evolution Reaction at Industrial-Level Current Density

Electrically Insulated Catalyst-Ionomer Anode Interfaces towards Durable Alkaline Membrane Electrolyzer

Interfacial and Vacancy Engineering on 3D-Interlocked Anode Catalyst Layer for Achieving Ultralow Voltage in Anion Exchange Membrane Water Electrolyzer

Bioinspired Spatially Topological Strategy Boosts the Anion Exchange Membrane for Industrial-scale Water Electrolysis

Improving the water electrolysis performance by manipulating the generated nano/micro-bubbles using surfactants

Scalable Fabrication of Highly Active and Durable Membrane Electrodes Toward Water Oxidation.

Accelerated Discovery of Multi-Metallic Nanostructured Catalysts for Anion Exchange Membrane Water Electrolyzers: Oxygen Evolution Reaction

PGM-Free Oxygen Evolution Reaction Catalyst for PEM Water Electrolysis – a Mechanistic Study on Activity and Durability for Practical Applications

PGM-Free Catalysts and Electrodes for Anion Exchange Membrane Water Electrolyzers

Synergistic Electrocatalysts Impact Efficient and Durable Oxygen Evolution Catalysis for Proton Exchange Membrane Water Splitting

(Invited) PGM-Free Oer Catalysts for PEM Electrolyzer Application

Novel Large-scale Integrated Non-Precious Metal Electrodes for Efficient and Stable Oxygen Evolution Reaction at High Current Density in 2.5 Kw Anion Exchange Membrane Water Electrolysis

Nanochannel electrodes facilitating interfacial transport for PEM water electrolysis

Hybrid 3D‐Ordered Membrane Electrode Assembly (MEA) with Highly Stable Structure, Enlarged Interface, and Ultralow Ir Loading by Doping Nano TiO 2 Nanoparticles for Water Electrolyzer

Optimizing Ionomer Distribution in Anode Catalyst Layer for Stable Proton Exchange Membrane Water Electrolysis

Pathways Toward Efficient and Durable Anion Exchange Membrane Water Electrolyzers Enabled By Electro‐Active Porous Transport Layers

Ordered Membrane Electrode Assembly with Drastically Enhanced Proton and Mass Transport for Proton Exchange Membrane Water Electrolysis

Performance and Durability of Membrane-Electrode Assemblies Using Non-Precious Metal Catalyst and a Hydrocarbon-Based Electrolyte for Anion Exchange Membrane Water Electrolysis

Anion Exchange Ionomers Enable Sustained Pure-Water Electrolysis Using Platinum-Group-Metal-Free Electrocatalysts

Investigation of Electrocatalyst and Ionomer Interaction in Anion Exchange Membrane Water Electrolysis