Abstract:Recently, a four-axis coordinate measuring machine (four-axis CMM), which consists of three linear axes and a single rotary axis, has been more widely used than a traditional three-axis CMM. The volumetric error influences the accuracy of the four-axis CMM. There are 27 parametric errors that contribute to the volumetric error. This study utilized a touch probe to measure the hole plate. This methodology can evaluate errors more accurately and reflect the operational conditions of the machines. The main procedures are as follows: (1) The hole plate was sequentially set up in three different planes. The touch probe was used to measure the hole plate using five different styluses. (2) The 27 parametric errors were analyzed using the coordinate deviations. The volumetric error was constructed using homogeneous transformation matrices. The volumetric error ranged from 0.35 to 1.55 μm without the single rotary axis and from 0.35 to 2.83 μm with the single rotary axis. (3) Three metrology instruments, namely a laser interferometer, an autocollimator, and a polygon-autocollimator, were used to validate the proposed methodology and verify the measured parametric errors. The absolute maximum differences compared to the laser interferometer for three parametric positioning errors and the autocollimator for six parametric rotational errors for the three linear axes were 0.56 μm and 0.54′′, respectively. Additionally, the absolute maximum difference of one parametric positioning error for the single rotary axis, compared with the polygon-autocollimator, was 0.75′′. The E n-values were 0.27, 0.54, and 0.27, respectively. These results demonstrate the effectiveness and reliability of the proposed methodology for the industry's four-axis CMMs.

Self-Calibration Vision Method and System for Automatically Moving CMM Stylus Into Micro Holes

A Micro-Coordinate Measurement Machine (cmm) for Large-Scale Dimensional Measurement of Micro-Slits

On-line Qualification of a Micro Probing System for Precision Length Measurement of Micro-Features on Precision Parts

Machining Precision Online Measurement of Large Span Pin Hole Using Structured Light

Real-time Measuring Method to Measure the Micro-Displacement of a Rotating Cutter in Precise Piston Noncylinder Pinhole Boring

Development of a Monocular Vision System for Robotic Drilling.

Robot Base Frame Calibration with a 2D Vision System for Mobile Robotic Drilling

An Improved Two-Point Real-Time Measuring Method for Radial Micro-Displacement Measurement on High-Speed Smart Boring Bar

Dynamic Error Modeling and Compensation of a Scanning Probe on CMM

Embedded displacement measuring device based on error separating technique of multi-circle overlapping three-probe method

Efficient Calibration of a Scanning Probe on CMM

Interior Profile Accuracy Assessment Method of Deep-Hole Parts Based on Servo Drive System

Hybrid vision control apply on automatic pneumatic micromanipulation system

Method of micro hole tilt adjustment based on a vision-guided touch probe

Measuring Parametric and Volumetric Errors in a Four-Axis CMM Using a Hole Plate

A high-accuracy circular hole measurement method based on multi-camera system

Uncertainty Evaluation Study of CMM Dynamic Measurement Based on Quasi Monte Carlo Method

A simultaneous calibration technique of the extrinsic and turntable for structured-light-sensor-integrated CNC system

Nanoprecision Measurement of High-Aspect-Ratio Microholes Using Sub-100-μm Tungsten Ball Tip

Research on Online Measurement Method for Small Workpiece Circular Holes Based on Machine Vision

Hole Position Detection Technology Of Thin-Walled Parts Based On Binocular Vision