Abstract:The introduction of hexagonal η-Ni 3 (Al,Ti) 0.5 Nb 0.5 phase can refine and homogenize the microstructure of IN718Plus superalloy during hot working, but produces more complicated recrystallization behavior associated with second-phase modified structural mechanisms. Derived from this perspective, the role of η phase on recrystallization mechanisms and grain development from dynamic deformation to post-dynamic dwell was systematically investigated. The results indicated that η phase delayed the throughout recrystallization procedure and grain development. During dynamic deformation, boundary η inhibited discontinuous dynamic recrystallization via preventing the bulging of original grain boundaries, while intragranular lamellar η promoted heterogeneous strain concentration, stimulated random dislocations for continuous dynamic recrystallization and dislocation walls for banded dislocation substructures, which limited recrystallization occurrence in dynamic stage. During post-dynamic dwell, boundary η dissolution increased the nucleation sites for discontinuous static recrystallization, and η phase restricted grain boundary migration to provide abundant nucleation sites for continuous static recrystallization (CSRX). The banded dislocation substructures slowly evolved into subgrains to further form banded CSRX grains, which reduced grain size during early post-dynamic stage. After fully recrystallization, the residual η protected the small grains and impeded grain growth, meanwhile controlled the grain distribution. As a result, η phase induced sluggish dislocation evolution and recrystallization nucleation, consequently suppressed grain development and obtained the more homogeneous and fine grain configuration.

Growth mechanisms of eta phase in 718Plus alloy

Minimum Interface Misfit Criterion for the Precipitation Morphologies of TCP Phases in a Ni-based Single Crystal Superalloy

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

Experimental and first-principles characterization of heterogeneous nucleation of η on the E(Al18Mg3Cr2) phase in the 7075 Al alloys

Atomic-scale Observation of the Interfaces Between Η and Γ Matrix in ATI718Plus

Study on the grain development and dislocation evolution from dynamic to post-dynamic stage in IN718Plus superalloy; the role of second-phase

Study of pre-precipitated 8 phase promoting deformation twinning and recrystallization behavior of Inconel 718 superalloy during hot compression

Study on Micro-Structural Properties of Pbte/Cd0.98zn0.02te (111) Hetero-System Grown by Molecular-Beam Epitaxy

Atomic-level characterization of η-twins with non-homogeneous nucleation on the E(Al18Mg3Cr2) phase in 7075 alloy: TEM observations and DFT calculations

The growth mechanisms of θ′ precipitate phase in an Al-Cu alloy during aging treatment

Transmission Electron Microscopic Investigation of the Γ→α Phase Transformation in a Ti–45Al–5Nb Alloy

Enhancing tensile properties of wrought Ni-based superalloy ATI 718Plus at elevated temperature via morphology control of η phase

Short Study on Mechanism of Morphology Change of γ′ Precipitates in IN718 Plus

Phase-field modeling of $γ/γ''$ microstructure formation in Ni-based superalloys with high $γ''$ volume fraction

Effect of the precipitation of the η-Ni3Al0.5Nb0.5 phase on the microstructure and mechanical properties of ATI 718Plus

The precipitation of η phase during the solution treatments of Allvac 718Plus

Transmission Electron Microscopy Investigation and Interpretation of the Morphology and Interfacial Structure of the ∊′-Mg54ag17precipitates in an Mg–Sn–Mn–Ag–Zn Alloy

Formation mechanism of lamellae during ¡ transformation in polycrystalline dual-phase Ti alloys

Solidification behavior of Pt-containing 718Plus superalloy

Tensile behavior and deformation mechanism for Ti–22Al–25Nb alloy with lamellar O microstructures

Evolution of microstructure and intervariant boundaries of α phase in electron beam melted and heat-treated Ti–6Al–4V alloy