Abstract:Micro-surface texturing design is becoming an important part of surface engineering since engineering practices and analyses have indicated that surface textures may significantly affect the tribological performance of contact interfaces. Advances in the manufacturing technologies of surface finishing and micro-machining, such as laser surface texturing, photolithography, and etching, LIGA process, have made it possible to fabricate different fine structures on various engineering surfaces. Though the influence of micro-surface texturing on hydrodynamic lubrication has been widely investigated over the last decade, such an influence may be complicated and difficult to characterize with only a few statistic surface parameters. Thus, very little attention has been paid to the effects of different textural shapes and orientations on hydrodynamic lubrication, which is the main topic of this article. A theoretical model based on a single dimple was established to investigate the geometric shape and orientation effects on the hydrodynamic pressure generated between conformal contacting surfaces. Using the Successive Over Relaxation method, the average hydrodynamic pressure generated by the texture pattern with the dimples in shapes of circle, ellipse, and triangle at different orientations to the direction of sliding are obtained. The results indicate that geometric shape and orientation have obvious influences on load-carrying capacity of contacting surfaces. With the same dimple area, area ratio and dimple depth given in this research, ellipse dimples perpendicular to the sliding direction showed the best load-carrying capacity. This result agrees with previous experimental results very well.

Investigating the Effect of Geometric Shape on Air Cushion Lift Force

Aerothermodynamic Shape Optimization of a Hypersonic Lifting Body

Multiobjective Shape Optimization of A Hypersonic Lifting Body Using A Correlation-Based Transition Model

Sensitivity-Based Parameterization for Aerodynamic Shape Global Optimization

An Analytical Model for Pressure Distribution in Automated Fiber Placement on Irregular Surfaces and Its Application in Aeronautical Manufacturing

Numerical Forecasting And Experiment Research Of The Air Flow Rate For The Air Cushion Vehicle

Numerical Study of Section Geometry of Flexible Bag of Air Cushion Vehicle Subjected to Slamming Loads

Some factors affecting lift force of air cushion vehicle in numerical simulation

Aerodynamic Shape Optimization with Grassmannian Shape Parameterization Method

Numerical Investigation on Pressure Responsiveness Properties of the Skirt-Cushion System of an Air Cushion Vehicle

Multi-Objective Optimization Design of an Origami-Inspired Combined Cushion Airbag

Geometrical parameters effect on aerodynamic performance of infinite tubercle leading edge wings

Numerical And Experimental Study On Air Cushion System Dynamics For Semi-Track Air-Cushion Vehicle

Influence of Geometry on Hydraulic Buffer Performance

Sea Keeping Analysis of Air Cushion Vehicle with Different Wave Angles under the Operation Resistance

Research on air cushion suspension support system with low speed and heavy load

Automotive Aerodynamics Analysis Using Two Commonly Used Commercial Software

Geometric Shape Effects of Surface Texture on the Generation of Hydrodynamic Pressure Between Conformal Contacting Surfaces

Aerodynamic Design Optimization of a Hypersonic Rocket Sled Deflector Using the Free-Form Deformation Technique

Research on the Transverse Stability of an Air Cushion Vehicle Hovering over the Rigid Ground

Hybrid Analytic-Fem Approach for Dynamic Response Analysis of Air-Cushion Vehicle Skirts