Abstract:This paper describes an investigation of the possible benefits from wing optimisation in improving the performance of Micro Air Vehicles (MAVs). As an example we study the Avion (3.64 kg mass, 1.60 m span), being designed at the CSIR National Aerospace Laboratories (NAL), Bengaluru. The optimisation is first carried out using the methodology described by Rakshith \emph{et al.} (using an in\textendash house software PROWING), developed for large transport aircraft, with certain modifications to adapt the code to the special features of the MAV. The chief among such features is the use of low Reynolds number aerofoils with significantly different aerodynamic characteristics on a small MAV. These characteristics are taken from test data when available, and/or estimated by the XFOIL code of Drela. A total of 8 optimisation cases are studied for the purpose, leading to 6 different options for new wing planforms (and associated twist distributions along the wing span) with an improved performance. It is found that the improvements in drag coefficient using the PROWING code are about 5%. However, by allowing the operating lift coefficient $C_L$ to float within a specified range, drag bucket characteristics of the Eppler E423 aerofoil used on Avion can be exploited to improve the endurance, which is a major performance parameter for Avion. Thus, compared to the control wing $W_0$ (with operating point at $C_L$ =0.7) used in the preliminary design, permitting a variation of $C_L$ over a range of $\pm$ 10% is shown to enhance the endurance of wing $W_4$ by 18.6%, and of wing $W_{6}$ with a permitted $C_L$ range of $\pm$ 50% by 39.2%. Apart from the philosophy of seeking optimal operating conditions for a given configuration, the advantages of optimising design parameters such as washout of a simple wing proposed in the preliminary design stage, is also demonstrated.

Geometrical parameters effect on aerodynamic performance of infinite tubercle leading edge wings

Effects Of Cambers On Gliding And Hovering Performance Of Corrugated Dragonfly Airfoils

Effects of Cambers of Corrugated Airfoils on Gliding Performance by Using Lattice Boltzmann Method

Effects of thickness and camber on aerodynamic performance of flapping wings during forward flight

Three-Dimensional Simulation of Micro Air Vehicles with Low-Aspect-Ratio Wings

Influence of Relative Thickness on Static and Dynamic Stall Characteristics and Prediction of Airfoils

Numerical analysis of low Reynolds number flows around thin wings for micro aerial vehicle

Optimal Settings of Aerodynamic Performance Parameters in Hovering Flight

Wing Optimisation for a tractor propeller driven Micro Aerial Vehicle

Aerodynamics of an Adaptive Wing for MAVs

Aerodynamic performance of a tandem wing configuration inspired from dragonfly gliding flight for MAV application

Biomimetic Wings for Micro Air Vehicles

Numerical Study on Effect of Leading‐edge Tubercles

Sensitivity Analysis of Wing Geometric and Kinematic Parameters for the Aerodynamic Performance of Hovering Flapping Wing

Aerodynamics of a bio-inspired flexible flapping-wing micro air vehicle

Effects of Aerodynamic Modeling on the Optimal Wing Kinematics for Hovering MAVs

Experiment Research on Aerodynamics of Flexible Wing MAV

A numerical investigation into the effects of Reynolds number on the flow mechanism induced by a tubercled leading edge

Experimental optimization of wing shape for a hummingbird-like flapping wing micro air vehicle

Numerical study of the aerodynamic effects of bio-inspired leading-edge serrations on a heaving wing at a low Reynolds number

The formation mechanism and impact of streamwise vortices on NACA 0021 airfoil's performance with undulating leading edge modification