Abstract:Introduction Low coherence interferometry offers the possibility of solving the ‘powering up’ problem associated with all fibre optic interferometric sensors used to measure slowly varying measurands such as temperature or displacement. In a typical system, the remote sensor is illuminated with the output form a source with low temporal coherence and interrogated using a second interferometer which is scanned such that its optical path difference (OPD) is maintained to be exactly equal to that of the sensor. In order that fibre optic sensors can compete with conventional electronic sensors it is desirable to be able to multiplex several sensors. A variety of multiplexing configurations for interferometric sensors exploiting low coherence processing have been developed, which include coherence tuning(l) and time division multiplexing (TDM)(2). Practical difficulties are experienced with both techniques. The main problems with coherence tuning are i) the optical path length of each sensor must be different (incremented by the source coherence length) which imposes restrictions on the sensor designs, particularly in the case for a network of miniature sensors, and ii) very high cross talk levels, as the recovered signal contains both the desired signal for the coherence tuned sensor and uncorrelated optical power from all the other sensors in the network, which inevitably results in very poor S/N ratios. The noise associated with the uncorrelated signals can be eliminated by exploiting TDM, however, as it is necessary to sequentially coherence match the local receiving interferometer (LRI) to each sensor, the technique is difficult to use in practice. Here we report two novel partially multiplexed configurations where the problems listed above can be solved by fully multiplexing the scanning interferometer and the signal processing unit, whilst at the same time the sensor network is only partially multiplexed. Configuration (1) Long Rang Tracking The basic optical configuration for long range tracking is shown in figure la. The output beam from a low coherence optical source (LCOS) is first collimated and directed into the transmission Michelson interferometer (TMI). The output signal of this interferometer is then injected into a 50/50 multimode coupler and then used to illuminate the two bulk optic Michelson interferometers acting as sensor simulators.

Asymmetric Beam Combination for Optical Interferometry

A Novel And Simple Heterodyne Interferometer Scheme

A simple beam combination for stellar interferometry

Universal Interferometer Based on Dynamically-Adjusted Fringe Periods

On-chip spectro-detection for fully integrated coherent beam combiners

Transport and magnetic properties of La_(1-x)Ca_xMnO_3-films (0.1<x<0.9)

Novel concept for visible and near infrared spectro-interferometry: laser-written layered arrayed waveguide gratings

Photonic beam-combiner for visible interferometry with SCExAO/FIRST: laboratory characterization and design optimization

Integrated optics for astronomical interferometry. I. Concept and astronomical applications

Mapping the aberrations of a wide-field spectrograph using a photonic comb

An infrared integrated optic astronomical beam combiner for stellar interferometry at 3-4 microns

Efficient injection from large telescopes into single-mode fibres: Enabling the era of ultra-precision astronomy

A six-apertures discrete beam combiners for J-band interferometry

Interferometry with few photons

Vision: A Six-Telescope Fiber-Fed Visible Light Beam Combiner for the Navy Precision Optical Interferometer

An Interferometrically Robust Opto-Mechanical Coupler to Beam Polarisation

Astrometry in two-photon interferometry using Earth rotation fringe scan

Practical demonstration of a six-telescope integrated optics beam combiner for the astronomical J- and H-band manufactured with ultrafast laser inscription

Simple multiplexing schemes for sensor networks exploiting low coherence interferometry

Array element coupling in radio interferometry I: A semi-analytic approach

An Approach to Upgrading the Beam Transport System at the Navy Precision Optical Interferometer