Microstructure and Mechanical Properties of TiC/WC-Reinforced AlCoCrFeNi High-Entropy Alloys Prepared by Laser Cladding

Zhikai Zhu,Wenqing Shi,Jiang Huang

DOI: https://doi.org/10.3390/cryst14010083

IF: 2.7

2024-01-17

Crystals

Abstract:By employing the technology of laser cladding, AlCoCrFeNi–TiC20−x/WCx high-entropy alloy coatings (where x = 0, 5, 10, 15, and 20 is the mass fraction) were fabricated on 316L stainless steel (316Lss). The effects of changes in different mass fractions on the morphology, phase composition, microstructure, microhardness, and corrosion resistance of the composite coatings were studied. This demonstrates that the addition of TiC and WC powder produces an FCC phase in the original BCC phase, the morphology and size of the coatings from top to bottom undergo some changes with x, and the grain size evolution follows a cooling rate law. The evolution of microhardness and corrosion resistance of the coatings exhibit a trend of increasing first and then decreasing with an increase in x. The coatings exhibited their best microhardness and corrosion resistance when x = 15, and their corrosion resistance and microhardness were much better than those of the substrate.

materials science, multidisciplinary,crystallography

What problem does this paper attempt to address?

The paper primarily explores the microstructure and mechanical properties of TiC/WC reinforced AlCoCrFeNi High-Entropy Alloy (HEAs) coatings prepared by laser cladding technology.

The research team prepared coatings on a 316L stainless steel substrate using TiC20-x/WCx high-entropy alloy powders with different mass fractions (x=0, 5, 10, 15, and 20). They systematically studied the effects of varying amounts of TiC and WC powders on the morphology, phase composition, microstructure, microhardness, and corrosion resistance of the composite coatings.

The study found that:
1. The addition of TiC and WC powders led to the formation of a Face-Centered Cubic (FCC) phase in the originally Body-Centered Cubic (BCC) phase.
2. The morphology and size of the coatings from top to bottom varied with the x value, and the evolution of grain size followed the cooling rate law.
3. The microhardness and corrosion resistance of the coatings showed a trend of first increasing and then decreasing with the increase of the x value.
4. When x=15, the coatings exhibited the best microhardness and corrosion resistance, and these properties were far superior to the substrate material.

The paper also describes the experimental process in detail, including the preparation of raw powder materials, the selection of experimental parameters, and the testing methods. Through the study of AlCoCrFeNi high-entropy alloy coatings reinforced with different proportions of TiC/WC materials, the relationship between the microstructure and mechanical properties of the composite materials was revealed, providing a theoretical basis for further optimization of such materials.