Abstract:Air pollution is becoming a serious issue because it negatively impacts the quality of life. One of the first most useful self-defense approaches against air pollution are face masks. Typically made of non-renewable petroleum-based polymers, these masks are harmful to the environment, and they are mostly disposable. Poly(butylene succinate) (PBS) is regarded as one of the most promising materials because of its exceptional processability and regulated biodegradability in a range of applications. In this regard, nanofiber-based face masks are becoming more and more popular because of their small pores, light weight, and excellent filtration capabilities. Centrifugal spinning (CS) provides an alternative method for producing nanofibers from various materials at high speeds and low costs. This current study aimed to investigate the effect of processing parameters on the resultant PBS fiber morphology. Following that, the usability of PBS nonwoven as a filter media was investigated. The effects of solution concentration, rotating speed, and needle size have been examined using a three-factorial Box-Behnken experimental design. The results revealed that PBS concentration had a substantial influence on fiber diameter, with a minimum fiber diameter of 172 nm attained under optimum production conditions compared to the anticipated values of 166 nm. It has been demonstrated that the desired function and the Box-Behnken design are useful instruments for predicting the process parameters involved in the production of PBS nanofibers. PBS filters can achieve an excellent efficiency of more than 98% with a pressure drop of 238 Pa at a flow rate of 85 L/min. The disposable PBS filter media was able to return to nature after use via hydrolysis processes. The speed and cost-effectiveness of the CS process, as well as the environmentally benign characteristics of the PBS polymer, may all contribute considerably to the development of new-age filters.

Optimisation of punching parameters for enhanced filtration performance of non-woven by response surface methodology

Layered nonwoven filter embodied with packing density gradient measured by X-ray computed tomography for enhanced filtration performance

Blend of Fibres to Improve the Mechanical Properties of Needle-Punched Nonwovens for PM2.5 Air Filtration

Modulating the structural characteristics of layered nonwoven fabrics devised by fibre fineness for enhanced filtration performance

Development of Needle-punched Nonwoven Fabrics from Flax Fibers for Air Filtration Applications

A comparative study of physical properties of nonwoven fabrics produced by uni- and bi-directional needles using response surface methodology

Filter quality coefficient: a way to optimize parameters of nonwoven used in filter

The influence of technological parameters on the filtration efficiency of electret needled non-woven fabrics

Air permeability of needle-punched filter media—virgin and recycled polyester

Some Studies on Water Permeability of Nonwoven Fabrics

Optimization on the performance of fibrous filter through computational fluid dynamic simulation coupled with response surface methodology

Virgin and recycled polyester filter media: effect of coating, calender roller pressure and roller temperature on dust filtration

Optimisation of cationic dye dyeing process of Porel fabrics using response surface methodology

Jute nonwoven-based hybrid fabric for flexible and impermeable packaging

Evaluation of high-modulus, puncture-resistance composite nonwoven fabrics by response surface methodology

Optimization of the Centrifugal Spinning Parameters to Prepare Poly(butylene succinate) Nanofibers Mats for Aerosol Filter Applications

Assessment of Physical and Mechanical Parameters of Spun-Bond Nonwoven Fabric

Optimization of the Green Fibre Paper Film Preparation Process Based on Box–Behnken Response Surface Methodology

Development of an asymmetric composite PPS-based bag-filter material through membrane laminating and superfine fiber blending: Lab test, field application and development of numerical models

Optimization of jute nonwoven fabric reinforcement for the development of a rigid composite

Enhancement of fiber attenuation and filtration quality via electrostatic-induction-assisted melt blowing