Mechanism, Microstructure and Performance of Novel Electron Beam Freeform Fabrication Compared with Conventional Method

Xi Shu,Guoqing Chen,Chunyu Wang,Chunju Wang,Lining Sun

DOI: https://doi.org/10.1016/j.vacuum.2024.113912

IF: 4

2024-01-01

Vacuum

Abstract:This paper proposes a new method: the pre-melting electron beam freeform fabrication method. This new method aims to mitigate the excessive heat input associated with directly forming a molten pool on the deposit and the poor formation caused by severe agitation of the molten pool. Consequently, it seeks to refine the internal microstructure of the part and enhance its mechanical properties. Using TC4 alloy as the research subject, this study performs a comparative analysis between the EBF and PEBF methods in terms of structural composition, deposit formation, cross-sectional morphology, microstructure, tensile strength, fracture path, and grain size. The research findings indicate that the PEBF method, due to its significantly lower heat input, results in the maximum α phase width being reduced to 1/4 to 1/5 of that observed with the EBF method. This reduction in α phase width leads to an increase in the tensile strength of the deposit from 784 to 840 MPa and an enhancement in the fracture strain from 0.22 to 0.34, which is close to the strength difference (68 MPa) calculated for the two methods using the Hall-Petch equation. The comparative results underscore the superiority of the PEBF method, demonstrating its potential to improve mechanical properties.