Abstract:Basic slag A exhibits a low viscosity, as prevalence of Q0(Si) and fewer Q3(Si) units. However, crystals tend to precipitate resulting in a sharp increase in viscosity. Acid slag B shows a higher viscosity due to a high prevalence of Q3(Si) units. And viscosity further increases with decreasing temperature, because Q0(Si) units combine with aluminate structures to form more Si–O–IVAl linkages. Viscosity is an important property for CaO‐SiO2‐Al2O3‐based slag systems, which showcases different scenarios in basic and acid slag systems with temperature change. This article elucidates the mechanism of their difference in viscosity–temperature property from melt structure. Results reveal that basic slag shows a low degree of polymerization (DOP) and a low viscosity of the melt due to an excessive O2− ions depolymerizing the complex network structures, resulting in more low‐polymerized Q0(Si) units and less high‐polymerized Q3(Si) units. With the temperature decreases, the DOP and viscosity do not change significantly. However, the low DOP and viscosity favor crystal precipitation in the melt, leading to a solid–liquid mixed state of the slag, and thus a sharp increase in viscosity when the temperature decreases to 1275 °C. For acid slag, it undergoes a transformation into aluminosilicate structures with the introduction of numerous [AlO4]5− tetrahedra, accompanied by a significant increase in the relative mole fraction of high‐polymerized Q3(Si) units. Consequently, the DOP and viscosity are obviously higher than that of the basic slag. Furthermore, the DOP and viscosity of the acid slag increase continuously with the temperature decreasing, thus impeding crystal precipitation and enhancing the glass transition tendency of the molten slag.

Viscosity and Structure Relationship with Equimolar Substitution of CaO with MgO in the CaO–MgO–Al2O3–SiO2 Slag Melts

Polymeric Structure Evolution Behavior Analysis of Aluminosilicate-Based Smelting Slag

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

Effect of W(mgo)/w(al2o3) Ratio and Basicity on Microstructure and Metallurgical Properties of Blast Furnace Slag

Fluidity and Structure of Aluminate Slags for Smelting High-Alumina Iron Ores: Effect of CaO/SiO2 Mass Ratio

Effects of Equimolar Substitution of BaO for CaO and Al2O3 for SiO2 on the Viscosity and Structure of CaO-SiO2-MgO-Al2O3-BaO Slag

Understanding the Relationship Between Structure and Thermophysical Properties of CaO-SiO 2 -Mgo-al 2 O 3 Molten Slags

Relationship Between Structure and Viscosity of CaO–SiO2–Al2O3–MgO–TiO2 Slag

Flowability and Structural Evolution of CaO-SiO2-MgO-Al2O3 Slag with Varying MgO/CaO Ratios:Experiments and MD Simulations

Effect of Al2o3/Sio2 Ratio on the Viscosity and Structure of Slags

Effect of CaO/MgO on Rheological Properties and Structure of CaO-MgO-SiO2-Al2O3-50% TiO2 Slag with SiO2/Al2O3=1.0

Relationship Between Structure and Viscosity of CaO–SiO2–MgO–30.00 Wt-%Al2o3 Slag by Molecular Dynamics Simulation with FT-IR and Raman Spectroscopy

Effect of BaO/Al2O3 Molar Ratio on the Viscosity and Structure of CaO SiO2MgO Al2O3BaO Slag

Evaluating the Effect of MgO/Al2O3 Ratio on Thermal Behaviors and Structures of Blast Furnace Slag with Low Carbon Consumption

Transition of Blast Furnace Slag from Silicates-Based to Aluminates-Based: Viscosity

Structural Interaction between BaO and Al2O3 in Aluminosilicate Slags

Effect of MgO and K2O on High-Al Silicon–Manganese Alloy Slag Viscosity and Structure

Influence of MgO, Al2O3and CaO/SiO2on the Viscosity of Blast Furnace Type Slag with High Al2O3and 5 Wt-% TiO2

An Insight in the Viscosity–Temperature Property of CaO‐SiO2‐Al2O3‐Based Slag Systems from Melt Structure

Molecular Dynamics Simulation on the Influence of Al2o3 on the Slag Structure at 1873 K

Effect of Al2o3, Mgo, and Cao/Sio2 on Viscosity of High Alumina Blast Furnace Slag