Abstract:A supercritical carbon dioxide (S-CO2) and Organic Rankine Cycle (ORC) combined cycle has been considered to fully use the residual heat of a high temperature heat source in this paper. The topping cycle is a S-CO2 recompression cycle, and the bottoming cycle is an ORC with R245fa as the working fluid. Compared with previous studies, the influence of several additional parameters, including the S-CO2 recompression cycle main compressor inlet temperature and pressure and the S-CO2 recompression cycle split ratio, has been conducted. It indicates that the split ratio plays an important role on the S-CO2 recompression cycle, even on the combined cycle. A thermodynamic optimization method which considers the split ratio is proposed to maximum the combined cycle thermal efficiency. By this method, more than 4.1% increment on the thermal efficiency can be attained. INTRODUCTION The supercritical carbon dioxide (S-CO2) is a special kind of CO2 fluid whose temperature and pressure are higher than its critical values (304.13K, 7.38 MPa). The S-CO2 cycle, which uses S-CO2 as the working fluid, is considered to be one of the most promising power generation technologies for the future (Feher, 1968). The S-CO2 cycle has higher efficiency and more compact system and components than conventional power cycles, especially in the high temperature range. Besides, CO2 is easy to obtain and the S-CO2 cycle system has high safety level. It is widely acknowledged that the S-CO2 cycle is applicable for various heat sources, such as the nuclear energy (Moisseytsev and Sienicki, 2009), concentrated solar power (Turchi and Ma, 2012), fuel cell (Xia et al., 2019) and waste heat recovery (Song et al., 2018a). One of the S-CO2 cycle characteristics is that the specific heat capacity of the cold side flow is much higher than that of the hot side in recuperators. For the S-CO2 recompression cycle, the CO2 flow is split to compensate for the specific heat difference in the low temperature recuperator and to further enhance the heat recuperation in the high temperature recuperator. Therefore, the residual heat is decreased and the S-CO2 recompression cycle has higher efficiency than simple recuperated cycle. The S-CO2 recompression cycle has been adopted by National Energy Technology Laboratory (NETL) of U.S. DOE for Supercritical Transformational Electric Power (STEP) program (Lambruschini et al., 2016).

Optimal Design of Supercritical CO2 Power Cycle for High Temperature Gas-Cooled Reactor

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Experimental and Numerical Study on Thermal Hydraulic Performance of Trapezoidal Printed Circuit Heat Exchanger for Supercritical CO2 Brayton Cycle

PARAMETRIC INVESTIGATION OF SUPERCRITICAL CARBON DIOXIDE BRAYTON CYCLE FOR HIGH TEMPERATURE GAS-COOLED REACTOR (HTGR)

A Study on Different Thermodynamic Cycle Schemes Coupled with a High Temperature Gas-Cooled Reactor

Features of Supercritical Carbon Dioxide Brayton Cycle Coupled with Reactor

Optimal design and thermodynamic evaluation of supercritical CO 2 oxy-coal circulating fluidized bed power generation systems

Thermodynamic Analysis and Optimization of a Supercritical Carbon Dioxide (S-CO2) Recompression Cycle Coupled with a Bottoming Organic Rankine Cycle

Design optimization and off-design performance analysis of one-dimensional supercritical CO 2 Brayton cycle

Performance Improvement Overview of the Supercritical Carbon Dioxide Brayton Cycle

An adaptive CO 2 Brayton-Rankine power cycle for efficient utilization of low environment temperature: A thermodynamic analysis and optimization study

Multi-objective Optimization of Combined Cooling, Heating, and Power Systems with Supercritical CO2 Recompression Brayton Cycle

Performance Comparison and Optimization of Two Configurations of (very) High Temperature Gas-Cooled Reactors Combined Cycles

Thermo-economic analysis and multi-objective optimization of supercritical Brayton cycles with CO2-based mixtures

Off-design performance analysis of supercritical CO 2 mixture Brayton cycle with floating critical points

Supercritical CO2 mixture Brayton cycle with floating critical points for concentrating solar power application: Concept and thermodynamic analysis

Performance of supercritical Brayton cycle using CO2-based binary mixture at varying critical points for SFR applications

Performance Analysis and Parametric Optimization of Supercritical Carbon Dioxide Cycle with Bottoming Organic Rankine Cycle

Design and performance analysis of compressor and turbine in supercritical CO2 power cycle based on system-component coupled optimization

THERMODYNAMIC ANALYSIS AND SYSTEM DESIGN OF THE SUPERCRITICAL CO2 BRAYTON CYCLE FOR WASTE HEAT RECOVERY OF GAS TURBINE

Primary Study on Carbon Dioxide Power Cycle of Htgr