Abstract:A wideband low-noise amplifier (LNA) with low and flat noise figure (NF) is presented in this article. For conventional wideband noise matching, the noise performance in the high-frequency region of the entire wideband is usually deteriorated due to the frequency-dependent nature of the minimum noise figure (NFmin) for a MOSFET. To address this issue, a novel wideband noise matching approach aiming at noise matching in high band is proposed. This approach can reduce the NF in high band at the cost of a slight NF increase in low band, eventually achieving a low and flat NF and thus a better overall noise performance for a wideband LNA. In addition, the multistage noise matching technique is employed at high frequencies to further reduce the NF caused by the second amplification stage. To validate the proposed techniques, a two-stage LNA prototype was designed and fabricated using a 65 nm CMOS process. The experimental results indicate a peak gain of 16.6 dB with a −3 dB bandwidth (BW) from 7.2 to 27.3 GHz (a fractional BW of 116%). Within the entire band of interest, the simulated NF is low and almost constant (3.3–3.4 dB), while the measured NF falls within the range of 3.30–3.72 dB. Considering the uncertainty of NF measurement, a 0.21 dB NF flatness is one of the best results among the reported millimeter-wave wideband LNAs. The measured third-order input intercept point (IIP3) is −6 dBm at 20 GHz, while the power consumption is 13.2 mW. In addition, only two passive transformers are used in this design, leading to a compact chip core area (0.14 mm2).

A 21.3-to-30.1 GHz Reversed Current-reuse LNA with Load Regulation Enhancing Wideband Noise and Input Matching

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A Gm-boosted and current peaking wideband merged LNA and mixer

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A 0.0081mm2 0.15–5.9-Ghz Low Noise Amplifier with Noise Cancelling and Current Reuse Techniques

A 23-30 GHz LNA with Noise-Cancelling in 28nm CMOS

High Gain and Low Power K-Band LNA with Reversed Current-Reuse Topology

A 0.061-mm2 1–11-GHz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward With Simultaneous Current and Noise Reduction

A wideband inductorless LNA exploiting three-stage feedback and thermal noise canceling

A 52–73-GHz LNA With Tri-Coupled Transformer for G m Boosting and Enhanced Noise Canceling

A High Gain and High Linearity Current‐reused CMOS LNA Using Modified Derivative Superposition Technique with Bulk‐bias Control

A 140-Gbps 1-to-21-ghz Ultra-Wideband LNA Achieving 1.95-to-3-db NF Using Gm-Assisted-Feedback Noise Suppression Technique in 40nm Bulk CMOS

A Wideband Inductorless LNA with Local Feedback and Noise Cancelling for Low-Power Low-Voltage Applications

A 10C18 GHz Current-Reused LNA MMIC With Feedback and Gain-Compensation Techniques

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

An inductorless wideband low noise amplifier with current reuse and linearity enhancement

A 24–30 GHz CMOS LNA with 2.05db NF and 0.6db In-Band Gain Ripple for 5G-Applications