Abstract:The cyclone separator has a simple structure but cannot effectively separate respirable dust of smaller particle sizes. The cartridge filter has a high separation efficiency, but its pressure drop increases too rapidly, requiring frequent cleaning operations. To make up for these defects, a novel cartridge-filtering cyclone combining both cyclone separator and cartridge filter is presented. Its performance parameters, including pressure drop, overall separation efficiency, grading efficiency, and cleaning interval, were studied experimentally and compared with those of the common cyclone and cartridge filter. The cartridge-filtering cyclone first pre-separates the larger particles by swirling airflow, and then filters out the fine particles through the filter cartridges, thus slowing down the increasing rate of the pressure drop and forming denser dust layers attached to the surface of the filter cartridges. The experimental results show that the cartridge-filtering cyclone has a better dust removal effect. At an inlet flow rate of 50 m(3)/h, the separation efficiency of the cartridge-filtering is 99.86%, which is 15.32% and 0.05% higher than that of the common cyclone and cartridge filter, respectively. In particular, the cartridge-filtering cyclone has a preferable separation effect on fine particles, with a separation efficiency for 2.5 mu m particles of 99.11%, which is 70.80% and 0.08% higher than that of the common cyclone and cartridge filter, respectively. Compared with the cartridge filter, the cleaning interval of the cartridge-filtering cyclone is extended and the total dust emission is reduced. Over the whole experimental period, the average cleaning interval and dust emission concentration of the cartridge-filtering cyclone are 1290.05 seconds and 12.06 mg/m(3) respectively, while that of the cartridge filter are 80532 seconds and 14.59 mg/m(3), respectively. (C) 2018 Elsevier B.V. All rights reserved.

The Effect of Cylinder Structure on the Pre-Dusting of Axial Separator

Experimental Study and Numerical Simulation of the Characteristics of a Percussive Gas–solid Separator

Micro Gas Cyclone Design and Performance Evaluation to Collect Dust Particles

Analysis of the Performance of a Novel Dust Collector Combining Cyclone Separator and Cartridge Filter

Dust dispersion during the pulse-jet cleaning process with the diffuser effect of the cartridge filter

Study on the influence of built-in open-hole dust cleaner on the cleaning performance of cartridge filter

Effect of Pre-Cladding Dust Layer on Filtration and Pulse-Jet Cleaning Performance of Filter Media

Influence of the inner diameter of the bottom plate on the cleaning performance of double-layer filter cartridges

Effect of annular baffles on the pulsed-jet performance of dust filter cartridge regeneration

Effect of Double-Layer Filter Cartridge with an Inner Cone on the Pulse-Jet Cleaning Performance of Cartridge Dust Collectors

Effect of horizontal cartridges on the uniformity of flow field distribution inside a cartridge filter

Performance Evaluation of a New Micro Gas Cyclone Using Simulation and Experimental Studies to Capture Indoor Fine Particles

Experimental Research on Separation Performance for Square Cyclone Separator under Different Constructional Details

Numerical analysis of cyclone separators with unique Dipleg structures at different Dipleg-to-dustbin ratios

Study on Effects of Particle Size and Maximum Pressure Drop on the Filtration and Pulse-Jet Cleaning Performance of Pleated Cartridge Filter

Numerical simulation of the particle-wall collision strength and swirling effect on the performance of the axial flow cyclone separator

Enhancement of particle collection efficiency considering the structural interplay: particle motion characteristics analysis

Effect of Cone Radius on the Pulse-Jet Cleaning Performance of Double-Layer Filter Cartridges (DL-FC)

Effect of Internally Mounted Helical Fins on the Separation Performance of a Cylindrical Gas-Solid Cyclone Separator

CFD Investigation on the Performance of Cyclone Separators with Divergent or Convergent Insertion Pipes

Separation Performance of New Type of Multi-Stage Axial Cyclone Used As Demister in Power Plant Emission System