Abstract:Filter cartridges with higher pleat ratios and larger filter surfaces are often cleaned incompletely because of the great variation in the static pressure distribution along the surface of filter cartridges during the pulse jet cleaning process. This study examined the static pressure distribution of filter cartridges and attempted to reduce the incidence of incomplete cleaning, particularly at the top of a filter cartridge, where less static pressure could cause systematic unstable operations. Pressure loss and static pressure behavior were observed across pleated filter cartridges in a dust collector during the pulse jet cleaning process. The instantaneous pressure drops of pleated filters were measured, and filter aging over time was recorded. The pressure drops of pleated filters with induced airflows are less significant than those without induced airflows. The static pressure and the continuous pressure time on the filter cartridges surfaces were obtained using a pressure transducer. The induced airflow was used to alter the static pressure distribution along the filter cartridge surface. The air axial velocity gradually decreased from the supersonic induced nozzle and through the air diffuser. Otherwise, radial velocity increased before encountering the filter cartridge surface, and the dynamic pressure was quickly converted into static pressure at the top of the filter cartridge before being transported to the middle of the filter cartridge and then immediately to the bottom. Sometimes, partial airflow moved into the filter cartridges and rebounded from the bottom of the filter cartridges, thereby forming partial static pressure at the bottom. Thus, the static pressure decreased from the top of the filter cartridge to the bottom. The experimental results show that the static pressure at the top area of the filter cartridges is 23–17kPa and the static pressure at the bottom area of the filter cartridges is 4.7–1.6kPa via the operational time with the 0.6MPa tank pressure in our experiment. The measured results are in good agreement with our photos. This variation resolved the cleaning difficulty at the top of the filter cartridge and maintained the entire systematic sustainable operation.

Experimental study of an improved pulse-jet cleaning method to enhance performance of cartridge dust collectors

Improved Pulsed-Jet Cleaning of Cone Filter Cartridges Using an Annular-Slit Nozzle

Improved performance of the opposing pulsed-jet cleaning by annular-slit nozzles for pleated filter cartridges

Effect of Double-Layer Filter Cartridge with an Inner Cone on the Pulse-Jet Cleaning Performance of Cartridge Dust Collectors

Study on the influence of built-in open-hole dust cleaner on the cleaning performance of cartridge filter

Characteristics and evaluation index of pulse-jet dust cleaning of filter cartridge

A new method to improve the pulse-jet cleaning performance of filter cartridges and its application to dust control in underground coal mines

Strategy and Consequence of Intermittent Segmented Pulse-Jet Cleaning for Long-Box-shaped Filter Dust Collector

Dust dispersion during the pulse-jet cleaning process with the diffuser effect of the cartridge filter

Experimental Investigation of the Optimization of Nozzles under an Injection Pipe in a Pulse-Jet Cartridge Filter

Numerical study of opposing pulsed-jet cleaning for pleated filter cartridges

Experimental Optimization for Cleaning Parameters and Field Application of Cartridge Filter in Bulk Grain Loading

Study on Effects of Particle Size and Maximum Pressure Drop on the Filtration and Pulse-Jet Cleaning Performance of Pleated Cartridge Filter

Experimental investigation on low-pressure pulse dust cleaning performance of plate-frame microporous membrane filter media

Effect of induced airflow on the surface static pressure of pleated fabric filter cartridges during pulse jet cleaning

Performance optimization of rectangular flat pleated filter with slit nozzle for dust cleaning

Analysis of the dust cleaning performance of a branch-type nozzle

The Synergistic Effect of the Filtration Area Controlled by the Electromagnetic Valve and Injection Pressure on Pulse-Jet Dust Cleaning Performance

Inhibition of Dust Re-Deposition for Filter Cleaning Using a Multi-Pulsing Jet

Effect of cone installation in a pleated filter cartridge during pulse-jet cleaning

Effects of Cleaning Mode on the Performances of Pulse-Jet Cartridge Filter under Varying Particle Sizes