Experimental investigation on low-pressure pulse dust cleaning performance of plate-frame microporous membrane filter media

Lumin Chen,Mengmeng Ye,Zhe Liu,Fuping Qian,Min Wei,Yunlong Han,Jinli Lu

DOI: https://doi.org/10.1016/j.powtec.2020.08.003

IF: 5.64

2020-09-01

Powder Technology

Abstract:<p>Mine dust removing systems mostly use wet dust collectors at present, according to the latest national emission standard, it is difficult to meet the emission requirements. Although the traditional bag filter can meet emission requirements, the water content of the particles is high in the mine, and the filter bag usually has the phenomenon of condensation, sticking to bags, and dust cleaning difficulties during use. Therefore, the experimental system was designed for low-pressure pulse dust cleaning of plate-frame microporous membrane dust collector, and the influence of different cleaning parameters on cleaning performance was studied, including the number of injection holes, injection distance, injection pressure and pulse injection time. And the optimal working conditions were selected to test the effect of the filter plate under the condition of powder attachment. The results show that the number of injection holes, injection distance and injection pressure have effects on the peak pressure, and the effect of pulse injection time on the peak pressure is implicit. The optimal conditions for the pulse cleaning operation parameters of plate-frame filter is 10 × Φ 5 injection hole, the injection distance of 20 mm, the injection pressure of 0.30 MPa, and the pulse injection time of 100 ms. On this basis, the cleaning effect of the filter plate with powder test is better, and the dust stripping rate φ was 92.9%, which is higher than 81%. The optimized plate-frame type dust collector has a better cleaning effect, indicating that the feasibility and applicability of pulse dust cleaning in plate-frame type dust collector have been improved.</p>

engineering, chemical

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the problems such as condensation, bag sticking and difficulty in cleaning when the traditional bag - type filter is used in a high - humidity environment in the mine dust removal system. Although the traditional bag - type filter can meet the emission requirements, due to the high water content of mine particulate matter, the above - mentioned problems often occur during the use of the filter bag. Therefore, the researchers designed a low - pressure pulse dust removal experimental system for the plate - and - frame microporous membrane filter medium, studied the influence of different cleaning parameters (the number of injection holes, injection distance, injection pressure and pulse injection time) on the cleaning performance, and selected the optimal working conditions to test the cleaning effect of the filter plate in the case of powder adhesion.

Specifically, the paper experimentally explored the following points:

1. **Number of injection holes**: The influence of different numbers of injection holes on the cleaning performance was studied. The results show that as the number of injection holes increases, the peak pressure also increases. The injection hole configuration of 10 × Φ5 was determined as the optimal working condition.

2. **Injection distance**: The influence of different injection distances on the pulse cleaning performance was analyzed, and it was found that the injection distance of 20 mm is the optimal working condition.

3. **Injection pressure**: The influence of different injection pressures on the cleaning performance was explored, and the results show that the injection pressure of 0.30 MPa is the optimal choice.

4. **Pulse injection time**: The influence of different pulse injection times on the cleaning performance was studied. It was found that the influence of the pulse injection time on the peak pressure is not obvious, but it is usually set to 100 ms in practical applications.

Finally, the researchers carried out a dust removal effect test under the optimal working conditions. The results show that the dust removal rate of the filter plate reached 92.9%, which is higher than 81% in other studies, proving that the optimized plate - and - frame - type dust remover has a better cleaning effect. This indicates that the feasibility and applicability of the pulse cleaning technology in the plate - and - frame - type dust remover have been improved.