Abstract:In this paper, we report on electrical and mechanical properties of isotactic polypropylene (PP) blended with polyolefin elastomer (POE) and propylene-based elastomer (PBE). Carrier trap distribution of the samples was estimated by isothermal surface potential decay measurement, while dc breakdown strength was measured through a pair of semicircle electrodes. Elongation at break and tensile strength were obtained to examine the variation in mechanical property of PP caused by the addition of elastomers. Furthermore, scanning electron microscope (SEM), differential scanning calorimetry (DSC), and dynamic mechanical analysis (DMA) have been employed to assist the understanding of morphology of the blends, thermal properties, and mechanical properties. Obtained results have indicated that with the increase of the elastomer content from 0 to 30 wt%, the trap depth appeared to be shallower and the dc breakdown strength tended to be reduced for both PP/PBE and PP/POE samples. Compared with PP/POE blend, PP/PBE blend had deeper trap depth, which should be responsible for its higher dc breakdown strength. In addition, PP/PBE blend has presented a better performance in elongation at break and tensile strength measurement. With the growth of the elastomer content, the crystallinity of the blends appeared to decrease, whereas the melting and the crystallization temperatures did not change remarkably. The SEM inspections and DMA results revealed better compatibility between PP and PBE compared with that between PP and POE, which should be the reason for the better electrical and mechanical properties of PP/PBE blend. The blend of PBE with low content could result in remarkably improved flexibility of PP with acceptable electrical strength for dc cable insulation.

Analysis of Influence of Trap Introducing Methods on Polymer Insulation Properties

Enhancement of Insulation Properties of LLDPE by PPy-functionalized PS-NPs

Correlation of Traps Inside XLPE and Polypropylene with Space Charge Dynamics under Polarity Reversal Condition

Influence of Clay and Predispersion Method on the Structure and Properties of Polystyrene (ps)‐clay Nanocomposites

Origins and effects of deep traps in functional group grafted polymeric dielectric materials

Deep Trap Origins, Characteristics, and Related Mechanisms in Chemically Grafted Polypropylene with Enhanced Direct Current Volume Resistivity

Influence of nano layer interface on space charge behavior and trap levels using polyimide sandwich structure

Trap Distribution and Dielectric Breakdown of Isotactic Polypropylene/Propylene Based Elastomer With Improved Flexibility for DC Cable Insulation

An Electron and Hole Trap Energy Distribution Estimation Model and Its Application in Polypropylene Nanocomposites

Electroluminescence and Surface Trap Distribution in Polymeric Insulation

Influence of Grafting Maleimide on the Insulating Properties in Polypropylene

Mechanism Study of Molecular Trap in All‐Organic Polystyrene‐Based Dielectric Composite

Quantitative trap analysis of grafting-modified polypropylene based on thermally stimulated depolarization current

Suppression of Elevated Temperature Space Charge Accumulation in Polypropylene/elastomer Blends by Deep Traps Induced by Surface-Modified ZnO Nanoparticles

Influence of Crystalline Phase on Conduction Current and Space Charge in Isotactic Polypropylene

Chemical Defects and Impurities Introduce Charge Traps to Silicone Rubber: a Quantum Chemistry Study

Quasi-Hydrogen Bond and Charge-Trapping Effect Originating from Polar Side Group Lead to Significantly Suppressed Charge Transport in Polypropylene

Large Improvement in Trap Level and Space Charge Distribution of Polypropylene by Enhancing the Crystalline − Amorphous Interface Effect in Blends

High Improvement In Trap Level Density And Direct Current Breakdown Strength Of Block Polypropylene By Doping With A Beta-Nucleating Agent

Correlation Between Trapping Parameters and Surface Insulation Strength of Solid Dielectric under Pulse Voltage in Vacuum

Analysis of trapping parameters in surface layer of solid insulating materials