Abstract:The operating safety of spacecraft in space environments is closely related to the surface discharging phenomenon of dielectrics such as polyimide (PI) film in solar arrays; moreover, carrier traps in the dielectric can affect its insulation performance. Therefore, to improve the vacuum surface flashover characteristics of PI film by nano modification and reveal the effect of trap distribution on the flashover of PI composite film, first, the original PI and nano-ZnO/PI composite films with different additive amounts (0.5, 1, 2, and 3 wt.%) were prepared by in situ polymerization and their performance was evaluated by the physicochemical properties characterized by methods such as thermogravimetric analysis; second, the surface traps of the original and nanocomposite films were measured and calculated by surface potential decay method, and the carrier mobility was also obtained; finally, the vacuum direct current (DC) surface flashover characteristics and bulk resistivity of all the film samples were measured and analyzed. The experiment results showed that with the increase in the amount of nano-ZnO, both the shallow and deep trap density increased significantly, while the trap energy varied slightly, and the surface flashover voltage also increased obviously. Based on the multi-core model, the increases in the shallow and deep trap density after the introduction of nano-ZnO into the PI matrix was analyzed from the microscopic perspective of the interface. Based on the comparative analysis of the trap distribution and surface flashover voltage characteristics, a bilayer model of vacuum DC surface flashover development was proposed. In the bilayer model, deep traps and shallow traps play a dominant role in the vacuum-solid interface and the inner surface of the dielectric, respectively, and increasing the trap density could effectively inhibit secondary electron multiplication on the surface and accelerate charge dissipation inside the film. Consequently, nano-ZnO can purposefully control the trap distribution, and then improve the flashover characteristics of nano-ZnO/PI composite films, which provides a new approach for improving the spacecraft material safety.

Correlation Between Trapping Parameters and Surface Insulation Strength of Solid Dielectric under Pulse Voltage in Vacuum

Investigation on Novel Characterization Parameters of Surface Flashover Phenomena in Vacuum

Correlation of Traps Inside XLPE and Polypropylene with Space Charge Dynamics under Polarity Reversal Condition

Analysis of trapping parameters in surface layer of solid insulating materials

Mechanism exploration of ion-implanted epoxy on surface trap distribution: An approach to augment the vacuum flashover voltages

Study on the Effect of Metal Particles on the Surface Trap Characteristics of Different Insulating Materials

Influence Mechanisms of Epoxy Degradation on Surface Traps and Charge Accumulation under DC Electrical–thermal Stress

Influence of the trap distribution on surface flashover performance of alumina ceramic

Surface Flashover of Alumina Ceramic Insulators in Vacuum

The control mechanism of surface traps on surface charge behavior in alumina-filled epoxy composites

The Correlation Between Surface Chemical Elements of Solid Insulating Materials and Their Flashover Characteristics in Vacuum

Analysis on Surface Charging of Insulator Prior to Flashover in Vacuum

Electric Field Analysis of Typical Surface Insulation Configurations in Vacuum

Effects of surface roughness on surface charge accumulation characteristics and surface flashover performance of alumina-filled epoxy resin spacers

Surface Charge Properties of Epoxy Composites under DC Voltage Affected by Surface and Bulk Conductivity

Dynamic Observation of Dc Surface Charge Dissipation for Epoxy-Resin/alumina Composite

An Experimental and Theoretical Investigation into the “Worm-Hole” Effect

Effect of Trap Regulation on Vacuum DC Surface Flashover Characteristics of Nano-ZnO/PI Film

Analysis of insulator surface charging due to charge injection and secondary electron emission in vacuum

Measurements of Electric Field and Charge on Insulator Surface

Electroluminescence and Surface Trap Distribution in Polymeric Insulation