Abstract:Cryogenic CO 2 separation from natural gas is a promising technology due to its environmental benefits and smaller spatial requirement. Nonetheless, the dynamics of CO 2 desublimation and subsequent frost layer formation under cryogenic conditions for natural gas pre-treatment remain largely unexplored. Addressing this gap, this paper presents a novel numerical simulation approach by integrating desublimation phase change model and vapor-solid phase equilibrium model to investigate CO 2 frost layer formation on the cold wall, revealing that both the cold wall temperature and the initial CO 2 concentration significantly influence the thickness of the CO 2 frost layer. Moreover, the study finds that the density of frost layer intensifies over time, with the highest density observed near the cold surface. Furthermore, increasing the cold wall temperature and the flow rate not only increases the average density of the CO 2 frost layer but also affects the outlet CO 2 concentration. To adhere to specific outlet CO 2 concentration targets and desublimation duration, it is critical to adjust the cold wall temperature and the inlet flow velocity dynamically. Therefore, cryogenic CO 2 removal methods, by reducing the spatial requirements of CO 2 pre-treatment units, offer a practical and efficient solution for small-scale natural gas liquefaction plants. This approach not only facilitates operational efficiency but also contributes to the broader effort of mitigating greenhouse gas emissions, aligning with environmental sustainability objectives.

Transient Model of Carbon Dioxide Desublimation in Plate-Fin Heat Exchanger of Cryogenic Reverse Brayton Refrigerator

Systematic Design and Optimization of a Membrane–Cryogenic Hybrid System for CO2 Capture

Spontaneous Desublimation of Carbon Dioxide in Turbo-Expander Applied for Cryogenic Carbon Capture

A Comparative Study on Regulation Methods for Transcritical CO2 Ejector Expansion Refrigeration System.

Optimal Design of a Subambient Membrane Separation System with Work and Heat Integration for CO2 Capture

Experiment investigation on carbon dioxide capture by cryogenic desublimation

Transient Cooling and Operational Performance of the Cryogenic Part in Reverse Brayton Air Refrigerator

Transient model of carbon dioxide desublimation from nitrogen-carbon dioxide gas mixture

Experimental Study of Carbon Dioxide Desublimation and Sublimation Process on Low Temperature Surface

A Preliminary Investigation Of Cryogenic Co2 Capture Utilizing A Reverse Brayton Cycle

Theoretical and Experimental Study for the Transient Behavior of a Linear Compressor During Pulse Tube Cryocooler Cool Down Process

An Optimal Multivariable Controller for Transcritical CO 2 Refrigeration Cycle with an Adjustable Ejector

Performance Analysis and Comparison of Cryogenic CO2 Capture System

Performance Investigation and Precooler Design of a Coupled Supercritical CO2-based Mixture Brayton Cycle with Absorption Refrigeration Cycle

Experimental investigation on continuous reaction crystallizer for CO2 capture by phase-change method

Thermodynamic study of carbon dioxide transcritical refrigeration cycle with dedicated subcooling and cascade recooling

Rating and performance of plate fin heat exchanger used for cryogenic separation of CO2

Performance investigation and precooler design of a coupled supercritical CO 2 -based mixture Brayton cycle with absorption refrigeration cycle

A novel numerical simulation approach for cryogenic CO 2 frosting in binary mixture gas by integrating desublimation and gas-solid phase equilibrium models

Evaluation of Viscosity and Thermal Conductivity Models for Co2 Mixtures Applied in Co2 Cryogenic Process in Carbon Capture and Storage (Ccs)

Experiment on a continuous heat regenerative adsorption refrigerator using spiral plate heat exchanger as adsorbers